Loading ...
Loading ...
Loading ...
Page 10
• Make sure the power switch is off (light will
be off).
• Unwind the power cord completely and plug
into a grounded 120 volt outlet.
• Turn on water supply at the faucet to
completely open.
• Turn the safety lock button on the spray gun
to unlocked. While pointing the spray gun
in a safe direction, squeeze the trigger on
the spray gun until there is a steady stream
of water, letting the water and air out of the
hose.
• Turn the power switch to the “ON” (|)
position. The unit will turn on for 1 - 2
seconds and shut off. This is a normal
function of the auto start feature. Squeeze
the spray gun trigger to begin pressure
washing.
• Squeeze the spray gun trigger to begin
OPERATING INSTRUCTIONS
K
lock
OFF/0
ON
/I
OFF/0
ON
/I
pressure washing.
• Begin pressure washer by squeezing the
trigger on the spray gun all the way into the
handle.
• Release the spray gun trigger to stop the
pressure washer.
• Allow the motor to come to a complete stop
before squeezing the trigger again.
• Squeezing rapidly will cause the auto start
feature to miss an on/off cycle that may
prevent it from turning on while squeezing
trigger after rapid squeezing. Use slow,
deliberate trigger pulls to avoid this.
• Always test a small area to avoid chance of
damaging the surface.
O
I
Adjusting Soap Levels on Foam
Cannon
Twist knob to adjust the level of soap as
indicated on the top of the Foam Cannon
(O). Twist toward the higher concentration
of bubbles for more soap, or the opposite
direction for less.
96048_IM_MFX2U2200.indd 1096048_IM_MFX2U2200.indd 10 2020/12/10 上午10:402020/12/10 上午10:40
Loading ...
Loading ...
Loading ...