Loading ...
Loading ...
Loading ...
4
Additional installation – XR.
Flush mount remote panel.
Additional installation – XR.
Proud mount remote panel.
Determine Remote Panel Location
Dimensions and layout are shown in
diagram 9. Panel can be installed on a
wall, benchtop or even inside a cupboard
Minimum cut out dimensions are 121mm
height x 70mm width. Minimum depth
must be 20mm.
Cut out cavity into the plaster wall.
Ensure the cable is pre-installed into the
flush mount bracket before plastering.
Place the flush bracket into the plaster
wall with the cable gap facing towards the
ground.
Installing the Remote Panel
Cable must be protruding out of the
bottom of bracket – see diagram 9.
Tape up the cable terminals before
plastering process – see diagram 10.
Determine Remote Panel Location
Cut out cable access hole in the desired
location.
Hole size must be Width 25mm x Height
45mm – see diagram 13.
Drill a pilot hole using bracket as a
template. The template could also be
used as a guide to cut into the plaster.
Install Mount Bracket
Fasten the mount bracket on to the
wall using phillips head screwdriver
(ensure the spring clips are facing up)
– see diagram 14.
Diagram 10
Plaster and Paint
Start plastering as required.
Wait for the plaster to dry before cleaning
the bracket.
Use a light sandpaper to give smooth
finish on the drywall.
Then paint as required.
Completing Installation
Take the tape off the cable connector and
plug it into the panel – see diagram 11
The panel and bracket are magnetic.
Upon install, the magnets will pull
together and secure the module into
place in place – see diagram 11.
Installation is finished – see diagram 12.
Magnetic remover tool may be
required again. Do not throw away.
Diagram 9
Diagram 12
Diagram 11
Install Cabling
Feed the cable through pre cut hole.
Screw and fasten the cable strain bracket
to the back of remote tap module.
Secure the tap module by sliding it
onto the previously installed bracket
– see diagram 15.
Completing Installation
Ensure panel is secured.
Clean up any excess plaster.
Installation is finished – see diagram 16.
Diagram 14
Diagram 13
Diagram 16
Diagram 15
70mm
20mm
121mm
BRACKET
PANEL
25mm
45mm
Loading ...
Loading ...
Loading ...