Loading ...
Loading ...
Loading ...
Fig. 11
Cut Wires
8
STANDARD OR ANGLE MOUNTING INSTRUCTIONS
10. Slide the downrod into the yoke of the motor
assembly, align the holes, and re-install the
downrod pin and downrod clip. Then re-tighten the
two set screws (Fig. 10).
11. Depending on the length of downrod you use,
you may need to shorten the wires to simplify the
wiring process. Pull the wires all the way through
the top of the downrod and measure 8 in. of lead
wire; use wire cutters (not included) to remove the
excess wire (Fig. 11).
12. If you cut back the lead wire in Step 11, strip 1/2 in.
of insulation from the end of each wire. Twist the
stripped ends of each strand of wire (Fig. 12).
Note: If you did not cut back the lead wires in Step
11, Step 12 is not necessary and you may proceed
to Step 13 instead.
Downrod
Yoke
Downrod
Clip
Downrod
Pin
Fig. 10
Fig. 12
Stripped
Wires
Loading ...
Loading ...
Loading ...