For models: GIR250
1000W RADIANT HEATER
OPERATING INSTRUCTIONS
1. Use only the voltage specified on the rating plate
of the appliance.
2. Keep all objects at least 1 metre from the front,
sides and rear of the appliance. Do not place
appliance close to radiant heat source.
3. Do not operate in areas where petrol, paint or
other flammable liquids are used or stored.
4. Do not insert or allow foreign objects to enter any
ventilation or exhaust opening, as this may cause
an electric shock, fire or damage to the appliance.
5. Do not operate this appliance with a damaged
cord, plug or after the appliance malfunctions or
has been dropped or damaged in any manner.
Return to a qualified electrical person for
examination, electrical service or repair.
6. This appliance is intended for household use only
and not for commercial or industrial use.
7. Use this appliance only as described in this
manual. Any other use is not recommended by
the manufacturer and may cause fire, electrical
shock or injury.
8. The common cause of overheating is deposits of
dust or fluff in the appliance. Ensure these
deposits are removed regularly by unplugging the
appliance and vacuum cleaning the air vents and
grills.
9. Do not use abrasive cleaning products on this
appliance. Clean with a damp cloth (not wet)
rinsed in hot soapy water only. Always removed
plug from the mains supply before cleaning.
10.Do not connect the appliance to mains voltage
until completely assembled and adjusted.
11.Switch off and use handles provided when
moving.
12.Do not operate with cord set coiled up as a heat
build up is likely, which could be sufficient to
become a hazard.
13.The use of an extension cord with this appliance
is not recommended.
14.Do not use this heater in the immediate
surroundings of a bath, a shower or a swimming
pool.
15. Do not remove plug from power socket until the
appliance has been switched off.
16. Do not remove plug from power socket by pulling
cord – always grip plug.
17. Always unplug appliance when not in use.
18. Do not locate the heater directly below any power
socket during operation.
19. Do not twist, kink or wrap the cord around the
appliance, as this may cause the insulation to weaken
and split. Always ensure that all cord has been
removed from any cord storage area and is unrolled
before use.
20. This appliance is not intended for use by young
children or infirm persons unless they have been
adequately supervised by a responsible person to
ensure that they can use the appliance safely.
21. Do not use this appliance in the immediate surrounds
of a bath, a shower, or a swimming pool or other
liquids. The appliance must not be immersed in any
liquids.
22. When the appliance has been unpacked, check if for
transport damage and ensure all parts have been
delivered. If parts are missing or the appliance has
been damaged, contact the Goldair Customer
Services Team. (refer to details on back page)
23. If your appliance does not work, or is not working
properly, contact the place of purchase or the Goldair
Customer Services Team. (refer to details on back
page). Repair work on the appliance by unqualified
persons can cause serious risk to the user.
24. There are no user serviceable parts installed in the
unit.
25. Do not put your fingers or other articles into or near
the air inlet or outlet. Do not sit on the unit.
26. Do not place the unit in wardrobes or other enclosed
spaces as this may cause fire hazards.
27. This unit is not supposed to be used in or around
locations where foodstuffs, works of art or delicate
articles of science, etc are stored.
28. Indoor use only.
29. Children should be supervised to ensure that they do
not play with the appliance.
30. Do not use this heater with a programmer, timer,
separate remote-control system or any other device
that switches the heater on automatically, since a fire
risk exists if the heater is covered or positioned
incorrectly.
WARNINGS AND SAFEGUARDS
OVERVIEW OF YOUR GOLDAIR RADIANT HEATER
Your Goldair Radiant Heater is designed to provide direct personal heating. The heater is equipped with two
heat settings to ensure your precise heating needs are met. An additional tip over safety device is built into
the product for added security.
OPERATING YOUR HEATER
Always choose a safe location for the heater, keeping in mind the safety precautions outlined. Ensure all
packaging has been removed from the unit before use.
HEAT CONTROL SWITCH
The control switch positions are:
• “0” = OFF
• “I” = Low Heat
• “II” = High Heat
Check that the heat control switch is set to the Off position before plugging the heater into the mains supply.
For greater economy, use the High heat setting initially and then switch to Low heat setting.
RADIANT HEATER SPECIFICATION
Model No: GIR250
Power Supply: 220-240V, 50Hz AC only
Power: 900-1000W
PROOF OF PURCHASE
To receive warranty retain receipt as proof of purchase. (Refer to back of booklet).
SUPPORT AND TECHNICAL ADVICE
North Shore City, Auckland, New Zealand
Monday – Friday 8am-5pm
Phone: 0800 232 633
Website: www.goldair.co.nz
SAFETY DEVICE ~ This appliance has two protection devices:
The first device, automatically disconnects & reconnects the appliance at a preset temperature,
The second safety device disconnects the appliance permanently in case of overheating, by means of a
thermal fuse. (It is non resettable)
IMPORTANT! ~ NEVER COVER THIS HEATER!
Covering the heater will cause activation of the non resettable safety fuse.
Your Goldair product has been inspected and tested and is guaranteed subject to the
following for a period to two years from the date of purchase against defects in
workmanship and materials. During this period, such defects will be rectified by
repair or replacement of the product purchased. Your product contains no user
serviceable components and this warranty becomes invalid if in our opinion the
product has been misused, abused, incorrectly installed, tampered with, connected
to an electrical supply not corresponding with the name plate specification, or
subjected to power surges. The warranty does not include any labour or other
associated expense that may be involved in removal or installation of the product.
Normal wear and tear is expressly excluded.
If your Goldair product fails to operate satisfactorily, please return it to the retailer
from whom it was purchased. To obtain a repair or replacement product under this
warranty, you will need to produce satisfactory evidence of date of purchase. The
completed warranty and purchase receipt must be presented with the product. The
warranty should be filled out at the time of purchase. It is in your interest to make
sure this is done.
If the product is to be replaced (cannot be repaired) then that replacement will be of
the same or similar product or accessory excluding packaging, instruction card etc.
Where a replacement product is supplied, this shall be guaranteed for the balance of
the original warranty period.
Any model that is no longer available will be replaced by a model of a value and with
such features as we consider appropriate in the circumstances. Goldair Ltd is not
responsible for freight forwarding charges, losses or damage in transit.
If service is required after the warranty period has expired, the product should be
returned to a qualified electrical technician. Service outside of the warranty period
will be at your cost.
Consumers GuaranteeAct (1993).
In accordance with the above act consumers are advised that: The manufacturer
does not undertake that repair facilities and parts are necessarily available for this
product.
If any of the provisions of the foregoing are contrary to any relevant legislation, then
that provision shall be deemed to be excluded from the warranty and the rest of the
provisions will continue to apply.
TWO YEAR WARRANTY
IMPORTANT: PLEASE RETAIN THIS WARRANTY CARD
NAME:
ADDRESS:
PURCHASED FROM:
SUBURB:
DATE OF PURCHASE:
NAME OF PRODUCT:
MODEL No:
.
