Loading ...
Loading ...
Loading ...
10
1. Remove Water Reservoir, Water Reservoir Lid, and Drip Tray,
wash in hot, soapy water. Rinse and dry.
NOTE: Do not wash any removable parts in dishwasher.
2. Wipe outside with a damp cloth and dry.
Care and Cleaning
w WARNING
Electrical Shock Hazard. Disconnect power before cleaning.
Do not immerse power cord, plug, or base in water or other liquid.
Water flow paused or unit made a brief noise during initial Filter flush.
Neither is a concern and should only happen during setup as air
is initially purged from the Filter. If the water flow pauses, simply
release Button, then press again to resume the water flow.
Blue ADD WATER and red FILTER LIFE Lights are flashing.
Water Filter is missing. Lights will flash until Filter is installed
correctly. Once Water Filter is inserted, lights stop flashing.
Water Filter is incorrectly installed. Remove Water Filter and
reinstall until you hear 2 clicks to ensure Filter is fully inserted.
Filter is difficult to insert.
Make sure that the Filter is inserted with Brita logo facing you.
Place hand on top of Brita Hub™ during filter insertion to provide
additional support.
Cup is overflowing.
Use a glass that is larger than the amount you are dispensing.
Blue ADD WATER Light is flashing.
Water Reservoir needs water. Fill Water Reservoir to MAX Fill line
and add back to Water Reservoir Base. Blue ADD WATER Light
will turn off after 12 oz, ( ) Manual Dispense, or 20 oz Button has
been pressed and water is detected in Water Reservoir.
Unit doesn’t dispense.
Replace Water Filter and reset Filter Life. Used Water Filter may
need to be replaced due to clogging from particulates. Do not
reset Filter Life without replacing Filter.
Water flow has slowed before end of Water Filter life.
OR
FILTER LIFE Light is blinking red before 6 months.
You may need to change your Filter more or less often than 6
months/120 gallons depending on amount and quality of water
you consume. For water with high levels of sediment, sand and/
or rust, Brita Hub™ Water Filter may need to be changed more
frequently to maintain desired flow rate.
Troubleshooting
Loading ...
Loading ...
Loading ...