Loading ...
Loading ...
EN
W415-3151 / 10.18.22
3
table of contents
1.0 getting to know your appliance 5
1.1 control access 6
1.2 rating plate information 6
2.0 operating your appliance 7
2.1 initializing the transmitter / battery holder for the first time 7
2.2 using your appliance 7
3.0 remote control layout 8
3.1 general transmitter layout 8
3.2 temperature display 8
3.3 flame height 9
3.4 blower speed 9
3.5 night light dimmer control 9
3.6 in the event of a power failure 9
3.7 continuous pilot / intermittent pilot (CPI/IPI) selection 9
3.8 eFIRE Controller application 10
3.9 low battery 10
3.10 battery holder / backup installation 10
4.0 operation 11
4.1 pilot-on-demand 12
5.0 clearances around appliance 13
5.1 optional heat management system 14
6.0 maintenance 16
6.1 care of glass 16
6.2 care of plated parts 17
6.3 safety barrier removal 17
6.4 firebox glass door removal 18
6.5 top and bottom door trim installation 18
7.0 replacement parts 19
8.0 accessories 20
9.0 troubleshooting 21
10.0 warranty 22
11.0 service history 23
Changes, other than editorial, are denoted by a vertical line in the margin.
Before reading this manual, be sure you know which model of appliance that you have. This information will have
been filled out by the installer on the following page and on the rating plate that is permanently attached to the ap-
pliance (see “rating plate information” section).
This manual is for the:
• Altitude™ X Series (AX36-1 and AX42-1 models)
If required, more detailed technical information is included in the appliance installation manual.
The information throughout this manual is believed to be correct at the time of printing. Wolf Steel Ltd. reserves
the right to change or modify any information within this manual at any time without notice.
Visit the Napoleon website for the most current version of your appliance’s manual.
Batteries must be disposed of according to the local laws and regulations. Some batteries may be
recycled, and may be accepted for disposal at your local recycling center. Check with your
municipality for recycling instructions.
This appliance is suitable for use with the Universal Heat Management system. THIS MANUAL DOES NOT
include detailed information relating the optional system. Framing and finishing are NOT the same. For further
details, refer to UHM instructions provided with the kit before starting installation.
Loading ...
Loading ...
Loading ...