Loading ...
Loading ...
Loading ...
9. Be sure the trailing edge of blade (op-
posite sharp edge) is up toward the
engine as shown.
10. Install the blade bolt with the lock
washer and hardened washer into
blade adapter and crankshaft.
11. Use block of wood between blade and
lawn mower housing and tighten the
blade bolt, turning clockwise.
• The recommended tightening torque is
35-40 ft. Ibs.
IMPORTANT: Blade bolt is heat treated.
If bolt needs replacing, replace only with
approved bolt shown in the Repair Parts
section of this manual.
12. Return mower to upright position.
13. Reattach drive cable spring to the idler
arm assembly, then reattach drive
cable to anchor.
14. Reattach drive cover with screws previ-
ously removed.
15. Connect spark plug wire to spark plug.
TO ADJUST HANDLE
The handle on your lawn mower has three
(3) height positions - adjust to the height
that suits you.
• Squeeze the bottom ends of lower
handle towards each other until the pin
in handle can be inserted into one of the
three height adjustment holes.
Hi
Low
piw
Handl,
ENGINE
ENG!NE SPEED
Your engine speed has been factory set.
Do not attempt to increase engine speed
or it may result in personal injury. If you
believe that engine is running too fast or
too slow, take your mower to a Sears or
other qualified service center for repair
and adjustment.
CARBURETOR
Your carburetor is not adjustable. If your
engine does not operate properly due to
suspected carburetor problems, take your
lawn mower to a Sears or other qualified
service center for repair and/or adjust-
ment.
IMPORTANT: Never tamper with the
engine governor, which isfactory set
for proper engine speed. Overspeeding
the engine above the factory high speed
setting can be dangerous. If you think
the engine-governed high speed needs
adjusting, contact a Sears or other
qualified service center, which has proper
equipment and experience to make any
necessary adjustments.
Immediately prepare your lawn mower for
storage at the end of the season or if the
unit will not be used for 30 days or more.
LAWN MOWER
When lawn mower is to be stored for a
period of time, clean it thoroughly, remove
all dirt, grease, leaves, etc. Store in a
clean, dry area.
.
15
1. Clean entire lawn mower (See
"CLEANING" in the Maintenance sec-
tion of this manual).
2. Lubricate as shown in the Maintenanc_
section of this manual.
3. Be sure that all nuts, bolts, screws, ant
pins are securely fastened. Inspect
moving parts for damage, breakage
and wear. Replace if necessary.
Touch up all rusted or chipped paint
surfaces; sand lightly before painting.
Loading ...
Loading ...
Loading ...