Loading ...
Loading ...
Loading ...
en-us
Eliminating minor faults yourself
Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following information.
Customer service will charge you for advice even if the appliance is still under guarantee!
Fault
Temperature differs greatly
from the set value.
Remedial action
In some cases it is adequate to switch off
the appliance for 5 minutes.
If the temperature is too high wait a few hours
and check whether the temperature has
approached the set value.
If the temperature is too low check
the temperature again the next day.
The light does not work. Light switch is jammed. Check whether the light switch can move.
The light is defective. (See chapter "Light".)
Controls have reduced lumi- When the appliance is not used for As soon as the appliance is again used, e.g. the
nosity, some time, the display on the fascia door is opened, the display switches back to nor-
switches to energy saving mode. mal illumination.
Displays do not illuminate. Power failure; Connect mains plug. Check whether the power
the fuse has been switched off; is on, check the fuses.
the mains plug has not been
inserted properly.
The temperature in Appliance opened frequently. Do not open the appliance unnecessarily.
the freezer compartment is The ventilation openings have been Remove obstacles.
too warm. covered.
Large quantities of fresh food are Do not exceed max. freezing capacity.
Freezer compartment door
was open for a long time;
temperature is no longer
reached.
Possible cause
being frozen.
The evaporator (refrigeration gener-
ator) in the No Frost system is cov-
ered in thick ice and can no longer
be defrosted fully automatically.
To defrost the evaporator, remove the frozen
food with the compartments, insulate well and
store in a cool location.
Switch off the appliance and move it away from
the wall. Leave the appliance door open.
After approx. 20 min. the condensation begins to
run into the evaporation pan, at the rear of the
appliance.
To prevent the evaporation pan from overflowing
in this case, mop up the condensation with
a sponge.
The evaporator is defrosted when the water
stops running into the evaporation pan. Clean
the interior. Switch the appliance back on again.
16
Loading ...
Loading ...
Loading ...