Loading ...
Loading ...
Loading ...
9
1. Remove the parts from the packaging.
2. Prior to initial use, clean your kettle by going through several boiling cycles,
using clean water with each cycle and filling the kettle to its upper marking.
The water will reach boiling point after approximately 5 minutes. The kettle
switches off automatically.
3. Discard the boiled water and wait for the kettle to cool. Then rinse the kettle
with cold water.
4. Your appliance is now ready for normal use.
5. Dispose of the packaging in a responsible manner.
1. Fill the kettle using either the spout or lid.
2. The water level must be between the MAX and MIN fill lines.
3. Check that the lid is closed correctly.
4. Ensure that both the base unit and the base of your kettle are not wet.
5. Place the kettle onto the base unit and plug in.
6. Switch the kettle on by pushing the ON/OFF switch to the ‘ON’ position.
7. Your kettle will begin to boil and will switch off automatically when it is done.
The ON/OFF switch will automatically move into the ‘OFF’ position when done.
Whilst the kettle is boiling the LED light on the ON/OFF switch will illuminate.
8. The kettle can be switched off manually by putting the On/Off switch to ‘Off’.
Note: The ON/OFF switch will also automatically return to the off position when it
is finished boiling.
Note: You can stop the boil process at any time by pushing the ON/OFF switch up
to the OFF position.
9. If you need to boil the kettle again, wait for a few seconds - allow the ON/OFF
switch time to reset.
10. When you lift the kettle up, you may see drops of water on the base. This is just
condensation from steam.
11. To avoid splashing or spilling, pour the kettle slowly and do not over-tilt it.
WARNING! NEVER REMOVE THE LID DURING BOILING
Tips: Improve the quality of your drinks by always using fresh water.
Empty the kettle after each use.
Be economical and do not boil more water than you need.
4 - Before First Use
5 - Using Your Appliance
Loading ...
Loading ...
Loading ...