Loading ...
Loading ...
Loading ...
8
ENGLISH
The XLR connectors use the following AES standard:
PIN 1 = GROUND (SHIELD)
PIN 2 = HOT (+)
PIN 3 = COLD (-)
HOT GND
BAL. XLR
COLD
CONNECTIONS
At this point you can connect the power supply cable and the signal cable, but before turning
on the speaker make sure that the volume control is at the minimum level (even on the mixer
output). It is important that the mixer is already ON before turning on the speaker. This will avoid
damage to the speakers and noisy “bumps” due to turning on parts on the audio chain. It is a
good practice to always turn on speakers at last and turn them off immediately after the show.
Now you can turn ON the speaker and adjust the volume control to a proper level.
BEFORE TURNING ON
THE SPEAKER
The top and bottom of the speaker is provided with a special mounting plate.
To the mounting plate accessories for pole mounting or truss clamping can be assembled.
TT+ speakers MUST be suspended only with RCF approved rigging hardware.
WARNING: Daisy chaining speakers always make sure that the maximum current
requirement does not exceed the maximum admitted POWERCON current. In case of doubt
call the closest RCF SERVICE CENTRE.
INSTALLATION
WARNING
The fuse settings/replacement shall be as follow:
TT 051-A II TT 052-A II
230 Volt, 50 Hz SETUP : FUSE VALUE T 1.25 A L 250 V
115 Volt, 60 Hz SETUP : FUSE VALUE T 3.15 A H 250 V
VOLTAGE SETUP
(RESERVED TO THE RCF SERVICE CENTRE)
Loading ...
Loading ...
Loading ...