Loading ...
Loading ...
Loading ...
Installation Instructions
[] CONNECTING THE REFRIGERATOR TO
THE HOUSE WATER LINE (cont.}
[_ If gou are using copper tubing, place a
compression nut and ferrule (sleeve) onto the
end of the tubing coming from the house cold
water supply.
If you are using the BE SmartConnect'"
tubing, the nuts are already assembled to
the tubing.
r_ if you are using copper tubing, insert
the end of the tubing into the refrigerator
connection, at the back of the refrigerator, as
far as possible. While holding the tubing,
tighten the fitting.
If gou are using BE SmartConnect'" tubing,
insert the molded end of the tubing into the
refrigerator connection, at the beck of the
refrigerator, and tighten the compression nut
until it is hand tight. Then tighten one
additional turn with a wrench. Overtightening
may cause leaks.
r_ Fasten the tubing into the clamp provided to
hold it in position. You may need to pry open
the clamp.
One of the illustrations below will look like the
connection on gour refrigerator.
Icemaker-Readg models
Tubing
Clamp
1/4" Copper
Tubing
1/4" Compression
Nut
Ferrule
(sleeve)
Refrigerator
Connection SmartConnect,,_
Tubing
Icemaker-lnstalled Models
Ferrule 1/4"
Refrigerator (sleeve) Compression
Connection--
SmartConnecff
Tubin_
TubingClamp
1/4" Tubing
21
[_] TURN ON THE WATER SUPPLY
(icemaker and dispenser models)
Turn the water on at the shut-off valve (house water
supply) and check for any leaks.
[_] PLUG IN THE REFRIGERATOR
On models with an icemaker,before plugging in the
refrigerator, make sure the icemaker power switch is set
to the 0 (off} position.
Seethe grounding information attached to the power
cord.
[_] PUTTHE REFRIGERATORIN PLACE
Movethe refrigerator to its final location. Make sure the
back side of the refrigerator engages the anti-tip
bracket properly. The anti-tip floor bracket should line
up with the cutout in the back bottom of the refrigerator,
and fit through the cutout when the refrigerator is
pushed into position. (Referto page 18, Step 2Afor more
information.)
E] LEVEL THE REFRIGERATOR
Turn the front roller adjusting
screws clockwise to raise the
refrigerator, counterclockwise
to lower it. Usea 3/8" hex
wrench with extension,or an
adjustable wrench.
Rolleradjustingscrews
To adjust the milers on 21' Counter Depth models:
Thesemodels also have rear adjustable rollers
so you can align the refrigerator with your kitchen
cabinets. Use a 3/8" hex wrench with extension to turn
the screwsfor the rear rollers-clockwise to raise the
refrigerator, counterclockwiseto lower it.
Loading ...
Loading ...
Loading ...