Loading ...
Loading ...
Loading ...
Sensors
(Odor sensor and PM2.5 Sensor)
Lens of PM2.5 Sensor
Dust box
14
Approximately Once a Month
1 Remove the inlet panel.
P. 8
2 Suck up the dust with a vacuum
cleaner using a nozzle.
Odor sensor
PM2.5 Sensor
Located on the right
side of the main unit.
3 Attach the inlet panel to the main
unit.
P. 8
Cleaning (Cont.)
When the Clean Dust Box Lamp Lights
Up or Approximately Once Every Four
Months
1 Remove the inlet panel.
P. 8
2
Pull out the dust box and then empty it.
Dust box
3 Attach the dust box.
Push the left and right of the
dust box.
If it is not attached properly, the removal of dust will become
difficult.
4 Attach the inlet panel to the main
unit.
P. 8
5 Insert the power plug and then reset
the Clean Dust Box lamp.
Press until you
hear the “blip”
sound (approx.
1 second).
l The Clean Dust Box lamp goes
out. (The lamp is reset.)
When you hear the “blip” sound, remove your
finger from the Reset button. If you keep the button
pressed, you will hear a “blip blip” sound and the filter
replacement timing will also be reset.
P.16
NOTE
Approximately Once Every Six Months
1 Remove the cover of
the PM2.5 Sensor.
Slide the cover to remove it.
2
Clean the lens with a dry cotton swab.
Do not use water,
alcohol, detergent,
etc.
This may cause a
malfunction.
3 Attach the cover of
the PM2.5 Sensor.
When you clean the unit and filters, always wear a mask and gloves, and wash your hands thoroughly after cleaning.
Loading ...
Loading ...
Loading ...