Loading ...
Loading ...
Loading ...
3736
FR
EN
NLNOFIITELSKPLUKBG DEDASVESPTCSHURUROHR
a. During the rst use of a steam cycle, if no steam comes out correctly:
Check that the hole in the tip is not clogged. See section above: “The steam nozzle of your machine appears to be partially
or completely clogged”.
Carry out the following protocol once and only once:
Empty the water tank and temporarily remove the Claris Aqua Filter System cartridge. Fill the tank with mineral water
high in calcium ( > 100 mg/L) and make successive steam cycles (5 to 10 cycles) in a container until a continuous jet of
steam is obtained. Put the cartridge back in the tank.
b. The steam nozzle had already worked:
Check that the hole in the tip is not clogged. See section above: “The steam nozzle of your machine appears to be partially
or completely clogged”.
If after performing the above steps, the steam Nozzle still doesn’t work, please contact KRUPS Consumer Service.
3. Steam escapes from the grid of the drip tray.
Depending on the type of preparation, steam may escape from the grid of the drip tray.
4. Steam appears under the bean container lid.
Check that the cleaning tablet funnel under the cover (L) is closed.
MAINTENANCE
1. The machine does not request descaling.
The descaling cycle is requested following preparation of a large number of milky or hot water-based drinks. If you only
make coee, descaling will not be required frequently.
2. Some grounds are in the drip tray.
A small amount of ground coee can get into the drip tray. The machine is designed to clear any excess ground coee so
that the percolation area remains clean.
3. The Intuitive Light Indicator remains lit after you have emptied the coee grounds collector.
Retting the coee grounds collector.
4. After lling the water container, the Intuitive Light Indicator stays on.
Check the container is positioned correctly in the appliance.
The oats at the bottom of the tank must move freely. Check and dislodge the oats if necessary.
DRINKS
1. The coee ows too slowly.
Turn the grinding neness button to the right for a coarser grind (depending on the type of coee used).
Perform one or several rinse cycles.
Change the Claris Aqua Filter System cartridge.
2. The coee is too light or not full-bodied enough.
Check that the bean container contains coee and that it is moving down correctly.
Avoid using oily, caramelised or avoured coees that may not be drawn into the machine correctly.
Decrease the preparation volume and increase the strength using the coee strength function. Turn the grinding neness
button to the left for a ner grind. Make your drink in two cycles using the two-cup function.
3. The Espresso or coee is not hot enough.
Increase the coee temperature in the machine settings. Heat the cup by rinsing it in hot water before preparing the drink.
Perform a coee system rinse before starting your coee. A coee rinse on start function can be activated in settings/auto-
rinse.
4. Clean water ows through the coee nozzles before each coee.
At the start of the recipe, there is a pre-infusion of coee which can cause a small amount of water to ow from the coee
nozzles.
If one of the problems outlined in the table persists, contact KRUPS Consumer Service.
!
Important: Manufacturer:
SAS GSM
Rue Saint-Léonard F-53104 Mayenne
France
Coee
temperature
Is your coee too hot? You can use this function to reduce the temperature. The machine has three
temperature settings for your coee drinks.
Water
temperature
Do you always drink the same tea and want to set the water temperature? This function is for you!
The machine has three temperature settings for your hot water.
Type of coee
Turns o the ‘No beans’ function. This function indicates a lack of coee beans in the container and
resumes a recipe which is in progress. See the GRINDER paragraph.
Factory reset
Resetting clears your preferences and settings and restores the default settings.
Your favourites will also be deleted.
TROUBLESHOOTING
OPERATION
1. The machine has a fault, the software is frozen OR the machine has a malfunction.
Turn o and unplug the machine, remove the lter cartridge, wait one minute and then restart the machine. Press and hold
the ON/OFF button for at least three seconds to start the machine.
2. The appliance does not turn on after pressing the ON/OFF button (for at least three seconds).
Check the fuses and the electrical power socket. Check that the plug is correctly inserted into the socket.
3. A power failure has occurred during a cycle.
The device will reset automatically when it turns back on.
4. The grinder is running empty.
This is normal if it is occasional and there are no or few coee beans left. It can run empty for up to ten seconds to determine
its consumption and ensure that it is working properly.
There are still coee beans in the container:
. The coee may be too oily and is not drawn into the machine properly. You can try encouraging the beans to fall and see if
it works again. However, we recommend changing the coee (see the bean type function).
. It is my usual coee that has worked well up until now: please contact your contact KRUPS Consumer Service.
USE
1. The grinder makes an abnormal noise.
There are most probably foreign bodies in the grinder. Try to clear it with a vacuum cleaner, otherwise contact your KRUPS
Consumer Service.
2. There is water under the appliance.
Before removing the drip tray, wait for 15 seconds after the coee has owed so that the machine nishes its cycle correctly.
Check that the drip tray is positioned properly on the machine. It must always be in place even when the machine is not in use.
Check that the drip tray is not full.
3. The adjustment button for the grinding neness is dicult to turn.
Only turn the grinding neness adjustment button when the grinder is running.
4. The appliance has not produced any coee.
An incident has been detected during preparation.
The appliance resets automatically and is ready for a new cycle.
5. You have used ground coee instead of coee beans.
Use your vacuum cleaner to clear the ground coee from the bean container.
6. Water ows from the coee nozzles when the machine is stopped.
This is normal. This is an automatic rinse to clean the coee nozzles and prevent them from getting clogged.
STEAM AND MILK
1. The milk ow from your machine appears to be partially or completely blocked.
An alert message will appear on the screen if the nozzle is blocked. Clean the «One Touch Cappuccino» block.
Refer to point 5 earlier in the instructions. MANUAL DEEP CLEANING OF THE MILK DISTRIBUTION SYSTEM –
5 MIN, or see the tutorial stored in your machine “Cleaning the milk nozzle”.
2. No steam comes out.