Loading ...
Loading ...
Loading ...
Page 10
Wall Installation
This type of installation is similar to roof mounting, ensuring that the pipe extends at least 55mm past the wall
surface refer gure 3. If the pipe length is shortened, reproduce the power cord exit slot on the inside of the
wall.
IMPORTANT FOR 950 MOTOR: Weather shield must be tted to the top cover of the side ange using the 3
screws provided. Also, it is required to use the hanging bracket for wall mount installation, for more information
please refer to page 11.
NOTE: By decreasing the length of the SteelFlex
™
duct from which specied (refer to installation instructions)
there will be an increase in airow and noise levels as a result. This increase in airow can cause movement of
air to be heard through the system and inhibit the system to run silently.
Figure 2: Wall installation
4. Installation
Wall
Backdraft Shutter*
200mm Metal Pipe
From outside face of wall cover plate to end of
pipe (or wall if cover plate not used)
28
Locking screws
Power cord to
220-240V supply
Fill gap between pipe and
wall or t second wall cover
plate if required
900
Motor
Wall cover plate (optional)**
Weather shield
must be at top
* With through wall installations ap shaft will be close to vertical.
IMPORTANT
It is a requirement to use the hanging bracket for all wall mount installations.
Please refer to the illustrations for mounting.
** Optional parts are available from Schweigen, please contact 1300 881 693.
Wall
Loading ...
Loading ...
Loading ...