01943
POWERING UP AND PAIRING REMOTE
Once blinking lights turn solid, drone is
ready to fly.
FLIGHT BASICS
FLIGHT CONTROLS
Turn on controller. Place the drone on level surface.Insert fully charged LiPo battery.
FLYING GUIDE
STUNT DRONE
FURY
FLIGHT MODES
NORMAL mode is best for
new pilots or those who
want a casual flying
experience. In NORMAL
mode, the drone reacts
smoothly to the pilot’s
input for easy control.
POSITION HOLD is active in both NORMAL and
SPORT modes. Simply let go of the control sticks
and the Surface Scan sensor will keep the drone
in a steady hover and will not drift away.
Ensure the Surface Scan view port on the underside of
the drone is free from obstruction.
SPORT mode allows for
experienced pilots to
perform more aggressive
maneuvers. The drone's
response rate to pilot
input is much higher for
sharper turns and more
speed.
Power Button
Flight Mode Button
Stunt Button
Rotate
Left
Rotate
Right
Up
Down
Fly RightFly Left
Fly Forward
Fly Backward
• If for any reason
you need to
immediately stop
the drone, press the
Power button to
initiate an
emergency disarm,
cutting power to the
motors.
LAUNCH/ LAND BUTTON
THROTTLE STICK DIRECTIONAL STICK
PRESS TO LANDPRESS TO LAUNCH
Press LAUNCH to automatically launch a few feet off the ground.
Move Throttle thumbstick up or down to make drone fly higher or
lower and left or right to rotate.
Use Directional thumbstick to fly forward, backward, left or right.
Press LAND to automatically land.
To make flying easier, place the drone on the ground in front of you with the
drone facing away from you (green blades forward). You should be facing
the same way the drone is facing.
L
AUTO
MANUAL
FLY ING MODE
R
R
R
L
L
1
R
2
L
You can also manually land the drone by holding throttle in the down
position to descend. Continue holding down once the drone reaches the
ground. When the drone recognizes it has landed, the controller will play
two beeps and the propellers will stop spinning.
LiPo BATTERY
ONE TOUCH STUNTS
BARREL ROLLS
While flying forward (or reverse),
tap the STUNT button.
If your drone is not functioning properly:
• Ensure the drone's LiPo battery is fully charged.
• Install fresh AAA batteries into the controller.
If there are still issues, you may need to calibrate the inertial sensors.
• Power on drone and place on a level surface. Power on controller.
• When controller is paired with drone, hold the Stunt and Flight Mode buttons for 2 seconds.
• Controller will play two beeps when the sensors have been calibrated.
FLIP IN 4 DIRECTIONS
While hovering, hold the STUNT button
and tap the direction stick in the
direction you want the drone to flip.
CAUTION!
The drone should be flying at least 10 feet in the air with a minimum clearance of
10 feet in all directions before attempting stunt functions.
TROUBLESHOOTING
2
R
STUNT
1
STUNT
Loading ...