Loading ...
Loading ...
Loading ...
4.
Hanging the Fan
REMEMBER
to turn off the power
. Follow
the steps below to hang your fan properly.
NOTE: This fan is recommended for
standard ceiling mount using the downrod
provided with this fan. When using standard
ceiling installation with the 6 inch downrod
provided, the distance from the ceiling
to the bottom of the fan blades will be
approximately 12 inches.
Standard Ceiling Mounting
1. Remove the canopy ring from the canopy
by turning the ring clockwise until it
unlocks. (Figure 5)
2. Remove the mounting bracket from the
canopy by loosening the four screws on
the top of the canopy
. Remove the two
non-slotted screws and loosen the slotted
screws. This will enable you to remove
the mounting bracket. (Figure 6)
4. Remove the hanger pin and locking pin
from downrod assembly.
5. Route the wires exiting the top of the fan
motor through the decorative motor collar
cover then the canopy ring. Make sure the
slot openings are on top. Route the wires
through the canopy and then through the
ball/downrod assembly
. (Figure 7)
Remove
Loosen but Do Not Remove
Turn Canopy Ring to Remove
Figure 5
Figure 6
6. Loosen, but do not remove, the set screws
on the collar on the top of the motor
housing.
7. Align the holes at the bottom of the
downrod with the holes in the collar on top
of the motor housing. (Figure 7)
Carefully insert the hanger pin through the
holes in the collar and downrod. Be careful
not to jam the hanger pin against the wiring
inside the downrod. Insert the locking pin
through the hole near the end of the b
o
lt
until it snaps into its locked position, as
noted in the circle inset of Figure 7.
8. Re-tighten the set screws on the collar on
top of the motor housing.
9. Make sure the grommet is properly installed
in the collar cover
, then slide the collar cover
on the downrod until it rests on the motor
housing. Be sure that the canopy and the
collar cover are both oriented correctly.
10. Proceed to “Installing the Fan” section.
FAILURE T
O PROPERLY INSTALL SET SCREWS
AS NOTED IN STEP 8 COULD RESULT IN FAN
LOOSENING AND POSSIBLY FALLING.
Figure 7
Tighten
Screw
Locking
Pin
Motor Wires
Ball/Downrod
Assembly
Ceiling
Canopy
Canopy
Ring
Motor Collar
Cover
Hanger
Pin
Motor Collar
Pin in Locked
position
Loading ...
Loading ...
Loading ...