Loading ...
Loading ...
Loading ...
20
21
Fill the dispenser slowly to avoid
spillage. Each dispenser will take
300ml from empty.
Undo the plug by turning it
anticlockwise.
Adjusting the rinse aid dispenser
3
Close the plug by rotating it clockwise.
NOTE:
It is important to clean up any spills
rinse aid, as it will cause excessive
foaming in the wash cycle.
To achieve the best drying result, with the least amount of rinse aid being used, the
dispenser can be adjusted by the user.
There are 5 levels of adjustment, the factory setting is D3. This setting will provide
excellent drying results.
If the dishes are not drying properly or with cloudy stains, the setting of D4 or D5 will
be required.
If there are sticky whitish stains on your dishes or a bluish film on glassware or knife
blades, the dispenser can be set back to either D2 or D1 to reduce any unnecessary
waste of rinse aid, whilst maintaining excellent drying results.
Follow the steps below:
on the dishwasher by press the Power button.
2. Within 60 seconds after step 1, press the Start/Pause button more than 5 seconds,
the rinse aid indication blinks.
3. Press the Start/Pause button to select the proper set according to your using habits,
the sets will change in the following sequence: D1->D2->D3->D4->D5->D1.
4. Without any operations in 5 second, or exit the set mode through the power
button, the new setting is active.
1. Switch
Loading ...
Loading ...
Loading ...