Loading ...
Loading ...
Loading ...
Instructions for the User
12
7. TROUBLESHOOTING GUIDE
Your new minibar
is designed and built to strict quality standards. This section is intended to enable you
to identify the origin of any malfunctions which may occur before contacting the Smeg After-
Sales Service.
PROBLEM
POSSIBLE CAUSE
PROBABLE SOLUTIO
N
Minibar not cooled sufficiently: - inside temperature setting thermostat
set too low () (this corresponds to
higher minibar temperature);
- turn the thermostat to ;
- door opened often or for long periods;
- open the door less often and for as
short a time as possible;
- door not closing properly; - check that the foods are arranged on
the shelves correctly and are not
preventing the door from closing
properly, and that the minibar is well
levelled on the floor;
- rise in outside temperature. - check that the gasket is sealing
properly and is not damaged.
Too much condensation forming in
minibar:
- check that the door gaskets are
providing an airtight seal on the
minibar;
- in case of cracks, try to soften the
gasket by pulling it with one hand and
sliding your closed fingers along the
inside;
- door opened often or for long periods;
- open the door less often and for
shorter times, especially when the
minibar is working in warm, humid
conditions;
- foods not properly covered or stored
in airtight containers.
- cover the containers and seal foods.
Temperature inside minibar too cold:
- cooling temperature thermostat
device set too high ().
- turn the selector to a lower setting ().
If the minibar does not work or it
malfunctions, make sure that:
- The plug is inserted correctly into the
electrical socket
- The electrical voltage is the same as
the one indicated on the DATA
PLATE
- The Minibar has not been placed
close to heat sources or in direct
sunlight
- There has not been a power failure
- Place the plug correctly in the power
socket
- Check, together with a qualified
technician, that the electrical voltage
is the same as that required by the
minibar
- Move the Minibar to a suitable position
- Wait for the power supply to come back
on (the Minibar may not operate
correctly for a few minutes).
Loading ...