Loading ...
Replacement Parts & Accessories
To purchase replacement parts or accessories, contact PetSafe
®
Customer Care Center at 1-800-732-2677 or by visiting www.petsafe.net.
Flap Replacement/Horizontal Flap Adjustment: The PetSafe
®
Panel Pet Door Insert
™
uses two PetSafe
®
large fl aps. To replace a fl ap, simply hold fl ap up and
unscrew the fi ve screws on the lower section of the inboard Hinge Plate. Replace with a new fl ap and return existing fi ve screws to secure fl ap back into place.
To horizontally adjust a fl ap, hold fl ap up and loosen the fi ve screws on the lower section of the inboard Hinge Plate. Adjust fl ap left or right for a snug fi t and
tighten screws back into place.
Vertical Flap Adjustment: To adjust fl ap vertically the Interior or Exterior Cover plate will need to be removed, depending on which fl ap is being modifi ed. Use a
small fl at head screwdriver to remove Finishing Plugs on the Interior or Exterior Cover. Loosen the fi ve screws on the upper section of the Hinge Plate and adjust
fl ap up or down for a snug fi t. Tighten screws back into place and replace Finishing Plugs.
NOTE: Vinyl fl aps shrink during cold months and stretch in warmer months and may need to be adjusted to ensure a proper fi t during seasonal changes.
Paintable Design: The PetSafe
®
Panel Pet Door Insert
™
was professionally painted during installation. If you need to repaint your pet door insert, the only
parts paintable are the Interior and Exterior Panels, Dual-Flap Mount, Bottom Mount, Interior and Exterior Cover Plates and Finishing Plugs. Any new paintable
parts should be primed before painting. T-grooves on the Exterior Panel Insert, the Dual-Flap Mount and Bottom Mount should not be painted to allow movement
after installation.
Closing Panel: Included with the PetSafe
®
Panel Pet Door Insert
™
is a plastic snap-on closing panel. Convenient, for those times when limiting access for your
pet’s entry and exit is necessary.
PetSafe
®
Panel Blank Insert
™
: If you no longer have the need for a pet door, you can replace your PetSafe
®
Panel Pet Door Insert
™
with the Panel Blank Insert
™
.
The PetSafe
®
Panel Blank Insert
™
provides the same paneled look without the pet door and is paintable.
In no event shall Radio Systems
®
Corporation be liable for any direct, indirect, punitive, incidental, special or consequential damages, or any damages whatsoever
arising out of or connected with the use or misuse of this Product. Buyer assumes all risks and liability from the use of this Product.
Under no circumstances will PetSafe
®
be liable for any labor charges or any expenses whatsoever in connection with the painting, removal, repair or installation of
this product.
Description Part #
Large Replacement Flap
PAC11-11039
Gray Replacement Hardware Kit
MPA00-12085
White Replacement Hardware Kit
MPA00-12118
Closing Panel
MPA00-12828
Gray PetSafe
®
Panel Blank Insert
™
RPA00-12746
White PetSafe
®
Panel Blank Insert
™
RPA00-12117
White Finishing Plugs (50)
MPA00-12823
Gray Finishing Plugs (50)
MPA00-12824
M3.5 x 20mm screws (50)
MPA00-12825
10427 Electric Avenue
Knoxville, TN 37932
www.petsafe.net
400-1162/2