Loading ...
Loading ...
Loading ...
8
9
www.barska.com www.barska.com
Lock Out Mode
1. THREE WRONG ngerprints are scanned consecutively; the ngerprint scanner
will shut down for 15 seconds.
2. Another THREE WRONG ngerprints are scanned consecutively; the ngerprint
scanner will shut down for 5 minutes.
3. After shutting down 5 minutes, if another THREE WRONG ngerprints are
scanned consecutively; the ngerprint scanner will shut down for 15 minutes.
4. During the shutting down period, the ngerprint scanner will not accept any
registered ngerprint. Only Emergency key can access the safe.
Reset to Factory Default Mode
1. Press inside of the safe initialization button consecutively for at least 5 seconds.
Then, the blue light will ash 3 times.
2. Under this operation, all registered ngerprints will be cancelled and the safe will
return to the factory default mode.
NOTE: Under factory default mode, the safe can be opened by any ngerprint.
Sound Options
Sound Off
With safe door open, place your registered nger on the ngerprint scanner. After the
ngerprint is conrmed successfully, place the same nger for another 5 seconds.
The blue light will ash 2 times, then sound will be off.
Sound On
Using the same operation as above, then you can turn on the sound
Lower Battery Warning
1. The RED LIGHT will ash to remind you the system power is low.
2. If the power supply is insufcient, please use Emergency Key to open the safe and
replace the batteries.
3. Battery replacement steps please refer to Install Batteries.
Mounting Instructions
The safe must be mounted to the oor. Be aware of the load bearing. Failure to do so
can result in personal injury and /or damage to property. Use appropriate tools when
use override key to open the safe & replace the batteries.
Floor Mounting
In order to mount the safe on the oor, please remove the feet at the bottom
rst. Use the hardware provided or counsel your local hardware retailers for your
particular surface.
- Use proper drill tools depending on the type of oor.
- Measure the location of the pre-set drill holes, mark their exact position onto
the oor.
- Drill the appropriate size holes for the anchors you are using.
- Carefully press the anchor into the holes at this time.
- Mount the safe by running screws from inside of the safe and securing to
anchors; ensure the safe is mounted securely.
Care and Maintenance
-
-
-
-
-
To maximize the security and performance of the safe, keep keypad clean; use a
dry cloth to remove any smudges after each use.
Keep liquids away from the control panel. Spills on the control panel will cause
damage and possibly electric shock.
Secure safe in a proper area to prevent from falling and causing damage
or injury.
DO NOT disassemble the product.
DO NOT use chemicals or cleaning agents to clean the safe.
Loading ...
Loading ...
Loading ...