Loading ...
Loading ...
Loading ...
H HII HII HII HII HII HII HII HII HII HII HII HII HII HII HII HII HII HII HII HII HII HII HII HII HII HII HII HII°Ipi IIi!RATi;!IiNiGi ;ii ii ilisTRU:ciT1° :
............ [] J
_o<R.oR_._oM,_c_,.__N_Y_,.__ FRIGIDAIRE o_ START
PLUS WAS_ VVAS_ CRYS1AL SAVER ONLY FAVORll_ HIGH SANITIZ AIRDRY SpRAy SCOR _IME CANCEL
PROF SS OF,_L
Your dishwasher uses a DishSenseTM Technology to understand how much food is on the dishes and then
adjusts the cycle accordingly.
Wash Cycle Selections
Cycle times are approximate and will vary with
options selected. Hot water is necessary to
activate dishwasher detergent and melt fatty food
soils. An automatic sensor will check the incoming
water temperature and, if it is not hot enough,
the cycle will be lengthened for automatic water
heating in the main wash and final rinse of all
cycles. This happens even when HIGH option
has not be selected. When HIGH is selected, an
even higher temperature will be reached to handle
heavier soil loads.
Option Selections
High
By pressing the HIGH pad, the option is selected.
The dishwasher heats water in main wash to
approximately 140°F (60°C).
This increase in water temperature helps
dishwasher detergent remove food grease and soil
from dishes more effectively and aids in drying.
Air Dry
The AIR DRY option in combination with rinse aid
will enhance drying performance. AIR DRY option
is not available on all cycles.
Spray
Press SPRAYpad to select this option. This varies
the pressure optimally for the cycle's intended
normal use.
Scour
Press SCOUR pad to select this option. This
provides a very high "scour" pressure. Due
to wash cycle optimization, this option is not
selectable in all wash cycles.
SPRAYand SCOUR can not both be selected to run
together.
Sanitize
To sanitize your dishes and glassware, select
SANITIZE option, by pressing SANITIZE pad.
When selected, the light will come on and remain
on until end of cycle. The water temperature in
the final rinse will be raised to 155°F (68°C) and
will maintain that temperature for 9 minutes. This
option is available in Power Plus and Normal Wash
Cycles. Only these sanitization cycles have been
designed to meet NSF requirements.
The cycle time will be extended until the proper
water temperature is reached. Washing action will
continue during the water heating delay. For best
results, the incoming water temperature should be
at least 120°F (49°C).
The sanitize criteria may not be satisfied if there is
an interruption of the cycle, power failure or if the
incoming water temperature is below 120°F (49°C).
Sanitize pad flashes at the end of the cycle if the
NSF requirements for sanitization are not reached.
To turn off the SANITIZE option, press the
SANITIZE pad. The SANITIZE light will turn off.
My Favorite Cycle
The MY FAVORITE CYCLE option allows you to
program your preferred cycle and options into one
button. Once Programmed, simply press the MY
FAVORITE CYCLE button followed by the START/
CANCEL pad will select the programmed cycle and
options.
To Program the MY FAVORITE CYCLEbutton:
1. Select your preferred cycle and options
2. Hold the MY FAVORITE CYCLE button for 3
seconds.
The LED over the MY FAVORITE pad turns on
indicating the MY FAVORITE CYCLE option has
been programmed. To change the MY FAVORITE
CYCLE option simply repeat steps one and two
above.
Loading ...
Loading ...
Loading ...