Loading ...
Loading ...
Loading ...
Maintenance Daily Weekly Monthly
Make sure that the battery charger is not
damaged.
X
Examine all cables, couplings and connec-
tions. Make sure that there is no damage or
dirt.
X
Clean the saw chain cover. X
Do a check of the connections between the
battery and the product. Do a check of the
connection between the battery and the bat-
tery charger.
X
Make sure that the pruner is not damaged.
Replace the pruner if it is damaged.
An approved Husqvarna dealer must do all servicing on the pruner.
Examine the wear of the chain drive sprock-
et.
Replace the chain drive sprocket after approximately 20 hours of
operation or more frequently if it is necessary.
To examine the cutting equipment
1. Make sure that there are no cracks in rivets and
links and that no rivets are loose. Replace if it is
necessary. (Fig. 67)
2. Make sure that the saw chain is easy to bend.
Replace the saw chain if it is rigid.
3. Compare the saw chain with a new saw chain to
examine if the rivets and links are worn.
4. Replace the saw chain when the longest part of the
cutting tooth is less than 4 mm/0.16 in. Also replace
the saw chain if there are cracks on the cutters. (Fig.
68)
To replace the guide bar and the saw
chain
1. Turn the locking knob counterclockwise and remove
the protective cover (A). (Fig. 69)
2. Remove the guide bar with the saw chain attached.
3. Remove the saw chain from the guide bar.
4. Put a new saw chain in the groove of the guide bar.
5. Install the new guide bar with the groove (B) onto the
bolt (E) and the hole (D) onto the guide bar pin (F).
6. Install the saw chain around the drive sprocket (G).
Make sure that the cutting teeth point in the direction
away from the drive sprocket (C).
7. Install the protective cover (A) and turn the locking
knob clockwise.
8. Tighten the saw chain. Refer to
To adjust the tension
of the saw chain on page 417
for instructions.
To sharpen the saw chain
Information about the guide bar and saw chain
WARNING: Use protective gloves
when you use or do maintenance on the
saw chain. A saw chain that does not move
can also cause injuries.
Replace a worn or damaged guide bar or saw chain with
the guide bar and saw chain combination recommended
by Husqvarna. This is necessary to keep the safety
functions of the product. Refer to
Accessories on
page 421
, for a list of replacement bar and chain
combinations that we recommend.
• Guide bar length, in/cm. Information about the guide
bar length and chain type can usually be found on
the rear end of the guide bar.
(Fig. 70)
• Chain pitch, in. The distance between the drive links
of the saw chain must align with the distance of the
teeth on the bar tip sprocket and drive sprocket.
(Fig. 71)
• Number of drive links. The number of drive links is
decided by the type of guide bar.
(Fig. 72)
• Bar groove width, in/mm. The groove width in guide
bar must be the same as the chain drive links width.
(Fig. 73)
• The guide bar must align with product.
(Fig. 74)
• Drive link width, mm/in.
(Fig. 75)
416
1867 - 005 - 26.10.2022
Loading ...
Loading ...
Loading ...