User Manual - Page 6

For SCS3014GQ2. Also, The document are for others Whirlpool models: SCS3004*, GLT3014*, SOS3014*, GLT3614*, SCS3614*, GLT3615*

Loading ...
Loading ...
Loading ...
I REMEMBER:When cooktoPtoparea may become hot. is in use, the entire cook- I
Fire Hazard
Do not let the burner flame extend beyond the
edge of the pan.
Turn off all controls when not cooking.
Failure to follow these instructions can result in
death or fire.
Electric ignitors automatically light the surface burners when
control knobs are turned to LITE,
Before setting a control knob, place filled cookware on the grate.
Do not operate a burner using empty cookware or while the grate
is vacant.
To Set:
1. Push in and turn knob counterclockwise to LITE.
All four surface burners will click. Only the burner with the
control knob turned to UTE will produce a flame.
2. Turn knob anywhere between HI and LO. Use the following
chart as a guide when setting heat levels.
SETrlNG RECOMMENDED USE
LITE Light the burner.
HI Start food cooking.
Bring liquid to a boil.
Medium HI Hold a rapid boil.
Quickly brown or sear food.
To fry chicken.
MED Maintain a slow boil.
Fry or saut6 foods.
Cook soups, sauces and gravies.
Medium LO Stew or steam food.
Simmer.
LO Keep food warm.
Melt chocolate or butter.
Power failure
In case of prolonged power failure, the surface burners can be lit
manually. Hold a lit match near a burner and turn knob
counterclockwise to UTE. After burner lights, turn knob to setting
Burner Use Suggestions:
Use the right front, right rear or left rear burners for simmering, or
for cooking smaller quantities of food requiring small cookware.
Use the left front POWER TM Burner for bringing liquids to a rapid
boil, cooking large quantities of food, or deep-fat frying requiring
large cookware.
S,:alvdSurfac,,£urne 's
23 /!\
I. Burner cap
2. Burner base
& Alignment pins
4. Igniter
& Gas tube opening
IMPORTANT: Do not obstruct the flow of combustion and
ventilation air around the burner grate edges.
Burner cap: Always keep the burner cap in place when using a
surface burner. A clean burner cap will help prevent poor ignition
and uneven flames. Always clean the burner cap after a spill-over
and routinely remove and clean the caps according to the
"General Cleaning" section.
Gas tube opening: Gas must flow freely throughout the gas tube
opening for the burner to light properly. Keep this area free of
soil and do not allow spills, food, cleaning agents or any
other material to enter the gas tube opening. Protect itfrom
spill-overs by always using a burner cap.
2
1. 1-1½"(25-38mm)
2. Burner ports
Burner ports: Check burner flames occasionally for proper size
and shape as shown below. A good flame is blue in color, not
yellow. Keep this area free of soil and do not allow spills, food,
cleaning agents or any other material to enter the burner ports.
Loading ...
Loading ...
Loading ...