Loading ...
Loading ...
Loading ...
5
1
5
4
3
2
Remove screw and washer (AA) from motor housing (D) . Place
back grill (C) against motor housing (D) aligning two upper stud nuts
with hole slots. Slide stud nuts down until bottom center screw hole
is aligned. Make sure fan housing ts between grille and stud nut’s
grommets. Secure back grille (C) using screw (AA).
Place motor housing (D) bottom bracket over end cap of inner pole
(E) and align holes. Install motor tightening screw (JJ). Install and
tighten motor mount screw (DD), motor mount nut (FF) and motor
adjustment knob (EE) to secure motor housing (D).
Motor and Grille Assembly
5
E
FF
DD
D
EE
Loosen mounting screw (GG) on fan blade (B) sleeve. Slide fan blade
(B) sleeve over motor housing (D) shaft (make sure end of screw is
positioned within at notch of shaft). Re-tighten mounting screw (GG)
on fan blade (B) sleeve.
2
3
1
3
2
1
7
D
B
1
3
22
6
D
AA
C
Remove grill screw (BB) and grille nut (CC) from bottom of grille
assembly. Open clasps on front grille (A).After placing front grille (A)
top clip over rear grill (C), place front grille (A) against rear grille (C).
8
C
A
Motor
Tightening
Screw
JJ
NOTICE
Remove protective sleeve from
motor shaft.
BBGG
CC
Fan style may vary.
Note:
Fan style may vary.
Note:
Loading ...
Loading ...
Loading ...