Loading ...
Loading ...
Loading ...
Positioning belt over pulley
With lettering on outside of belt, pinch
belt into a loop and twist slightly to
slide new belt over motor pulley (G).
Positioning belt over brush
roll
insert brush roll through belt and place
belt in belt guide (H) on brush roll.
Installing brush roll
Grasp brush roll firmly and fit it into posi-
tion by first sliding belt side into the rec-
tangular slot (I) on side of cleaner.
Pull other side of brush roll (J) into place.
Turn brush roll making sure belt is not
pinched between brush roll and cleaner
base.
Agitator brush roll
replacement
Replacing bottom plate
Line up bottom plate with front edge of
cleaner and rotate it into position.
Reposition the 2 Phillips head screws.
Tighten screws securely.
When to replace
Disconnect cleaner from electrical
outlet
What to buy
When purchasing a new brush roll, as
for Hoover part No. 48414-081.
How to replace
Disconnect cleaner from electrical
outlet.
1. Remove bottom plate, belt and brush
roll following directions for Fig. 3-8
and 3-9.
2. Discard old brush roll
3. Continue following the directions for
"Belt replacement" starting with
Fig. 3 11 to reposition belt, new
brush roll and bottom plate.
When brush roll brushes are worn, it
should be replaced.
To check condition of brushes, move
edge of a card across bottom plate
while turning brush roll. To maintain
cleaning effectiveness, replace brush
roll if brushes do not touch card.
Lubrication
The motor is equipped with bearings
which contain sufficient lubrication for
the life of the motor. The addition of
lubricant could cause damage. Do not
add lubricant to motor bearings.
The agitator is equipped with two ball
bearings that should be lubricated
periodically by a Hoover Factory
Service Center or an Authorized Hoover
Warranty Service Dealer (Depot).
Service
To obtain approved HOOVER service
and genuine HOOVER parts, locate
the nearest Hoover Factory Service
Center or Authorized Hoover
Warranty Service Dealer (Depot) by:
• checking the Yellow Pages
under "Vacuum Cleaners-
Household" OR-
• checking the list of Factory
Service Centers provided
with this cleaner OR -
• calling 1-800-944-9200 for an
automated referral of authorized
service outlet locations
(US. only) OR -
• checking the Service section of
The Hoover Company on-line at
www.hoover.com
Do not send your cleaner to The Hoover
Company in North Canton for service,
this will only result in delay.
If further assistance is needed, contact
The Hoover Company Consumer
Response Center, North Canton,
Ohio 44720, Phone: 330-499-9499.
In Canada, contact Hoover Canada,
Burlington, Ontario L7R 4A8,
Phone: 1-800-263-6376.
Always identify your cleaner by the
complete model number when
requesting information or ordering parts.
(The model number appears
on the bottom of the cleaner.)
Cleaning Effective-
ness Per Amp Rating
This is not an Amp rating. Amps do not
measure dirt removal, only the amount of
electricity used. Cleaning Effectiveness
Per Amp is determined by dividing this
model's Cleaning Effectiveness* by
its Amps.
*Cleaning Effectiveness is the percent
value obtained from dividing:
(a) the geometric mean of the amount of
embedded carpet dirt removed in
testing under ASTM Test Method
F608-89, by
(b) the value 29 (the geometric mean of
the midpoints of the % dirt pickup
scales selected by Hoover as a
reference for its rating system).
11
Loading ...
Loading ...
Loading ...