Loading ...
Loading ...
Loading ...
8
6.2 Unpacking
Open shipping container and check for shipping
damage. Report any damage immediately to
your distributor and shipping agent. Do not
discard any shipping material until the
Shear/Brake/Roll machine is assembled and
running properly.
Compare the contents of your container with the
following parts list to make sure all parts are
intact. Missing parts, if any, should be reported
to your distributor. Read the instruction manual
thoroughly for assembly, maintenance and
safety instructions.
Contents of Shipping Container
1 Shear, Brake and Roll machine
2 Handle assemblies
2 Guide rods with hex nuts
1 Guide plate
2 Mounting Blocks with T-handles
1 Instructions and Parts Manual
1 Warranty Card
6.3 Assembly
Tools required for setup and assembly:
5, 6, 8mm hex keys (“Allen wrenches”)
19mm open end wrench
1. Finish removing crate from around machine.
2. Remove bolts holding machine to pallet.
3. Carefully clean all rust protected surfaces
with a mild solvent or kerosene and a soft
rag. Do not use lacquer thinner, paint
thinner, or gasoline, as these may damage
painted surfaces.
4. Coat all machined surfaces with a very light
film of oil to inhibit rust.
5. Carefully move machine to a work bench or
stand. Machine location must allow free
access on all sides.
6. Bolt machine to stand or workbench. The
stand or workbench must be bolted to the
floor.
(NOTE: An optional stand is available for
this machine; see Section 9. Contact your
JET distributor to order.)
7. Remove one handle (A, Figure 3) from each
operating handle assembly, using 8mm hex
key.
Figure 3
8. Loosen lock bolt (C, Figure 3).
9. Slide bar (B) into hub and tighten lock bolt
(C) to secure.
10. Re-install handle (A).
11. Install both guide rods into either the upper
or lower set of threaded holes (Figures 4/5)
and tighten the setting by rotating hex nut
against the cast base of the machine with
19mm wrench.
Figure 4
(Brake position)
Figure 5
(Shear position)
Loading ...
Loading ...
Loading ...