Loading ...
Loading ...
Loading ...
Installation Steps :
Fig.1
Turn OFF the electric power at the
main fuse or circuit breaker box.
Left fan motor assembly
and hang on mounting
plate with hook provided,
through one of the two
holes in canopy. This will
allow for hands-free wiring.
CAUTION: Use only a side
with hole in canopy, not
hook slot.
PAGE: 5 / 8
INSTALLATION INSTRUCTIONS
NOTE: The fan weight is 15.65 lbs (7.1 kg). Be sure the outlet box you are using is securely attached to the building
structure and can support the full weight of the fan. Failure to do so can result in serious injury.
Screw the safety cable hook to the ceiling outlet box. (Make sure the outlet box
is securely installed so that it will be able to support at least the fan weight.)
Pull the wires from outlet box through the center hole of mounting plate. Attach the
mounting plate to the outlet box by using two washers and mounting screws.
WARNING: MOUNT ONLY TO AN OUTLET BOX MARKED "ACCEPTABLE
FOR FAN SUPPORT"!
.
Fig.2
Safety Cable Hook
Ceiling
Mounting Plate
Outlet Box
Washer
Mounting Screw
Fig.3
Mounting Plate
Fan Motor
Assembly
Fig.4
IMPORTANT:
BEFORE YOU BEGIN INSTALLING THE FAN, CAREFULLY READ ALL INFORMATION N THE SEPARATE
SHEET "SAFETY INSTRUCTIONS" AS WELL AS THE FOLLOWING "INSTALLATION INSTRUCTIONS". IF IN
DOUBT, CONSULT A QUALIFIED ELECTRICIAN.
SAVE ALL INSTRUCTIONS.
Fig.6a
Antenna
SUR Switch
Transmitter
Receiver
SUR
ON
ON SUR
Pull the safety cable
out of fan motor
assembly and
through the center
hole of mounting
plate, then hang it
into the safety cable
hook.
Safety Cable
Hook
Mounting
Plate
Fan Motor
Assembly
Fig.5
Safety Cable
ON SUR
Fan Motor
Assembly
Receiver
Fig.6
Note: The ceiling fan may work abnormally if there is interference from other remote controls.
Both the transmitter and receiver have a 4-key
unit code on each SUR Switch (Fig.6) and by
default, all keys are pre-set to the "off" position.
This means that the transmitter and receiver are
already paired together. However, if you have
multiple fans and remote controls and want to
avoid interference between them, you can "pair"
other transmitters and receivers together by
adjusting the SUR switches, so the same
numbered keys are in the "ON" position
on both (Fig.6b).
220407
Loading ...
Loading ...
Loading ...