Ancona AN-1211 USER INSTRUCTIONS

Loading ...

NEW INSTALLATION:

SAFETY WARNING:

Risk of electrical shock. This range hood must be properly grounded. Make sure this is done by a qualified

electrician in accordance with all applicable national and local electrical codes. Before connecting wires, switch

power off at service panel and lock service panel to prevent power from being switched on accidentally.

Step 6: Venting

certified aluminum or foil tape so that it is air tight. Please check the

Step 7: Electrical Connection

DON’T FORGET TO CONNECT THE GROUND!

Step 8: Installing Filters

Step 5: Installing the Hood

hood

• Open the wiring compartment and secure the leads inside.

• Please use a bushing on the cut-out opening to protect the electrical wires.

• WARNING: ALL CONNECTORS MUST BE ENCLOSED

IN THE WIRING COMPARTMENT.

• Using measurements provided on Page 16, measure and drill

4 holes into bottom of cabinet. (See Fig #4)

• Depending on exterior venting chosen (See page 7), use

measurements provided on Page 16 and cut vent hold in cabinet.

• Align range hood to the holes in the bottom of the cabinet and

screw in using the supplied screws. (See Fig #4)

Fig #4

Fig #5

Fig #

building codes in your city to learn which tape product is recommended.

• After the power is connected, place the

power cord back to power case. (Fig #6)

Fig #6

Loading ...

Ancona AN-1211 30 in. Slim DR2 Twin Motor Under Cabinet Range Hood