Loading ...
Loading ...
Loading ...
4. Press (B).
This enables adjustment of hour hand,
minute hand, and 24-hour hand
alignment.
30
Hour hand
Minute hand
24-hour hand
5. Rotate the crown to align the hour hand,
minute hand, and 24-hour hand with 12
o’clock.
6. Press (B).
This enables adjustment of small hour
hand, small minute hand, and small 24-
hour hand alignment.
30
Small hour hand
Small minute hand
Small 24-hour hand
7. Rotate the crown to align the small hour
hand, small minute hand, and small 24-
hour hand with 12 o’clock.
8. Press (B).
This enables function hand and day
indicator alignment.
30
30
Function hand
Day indicator
9. If the function hand and/or the day
indicator is out of alignment, rotate the
crown to adjust them. Move the function
hand to 12 o’clock and/or the day to the
center of the indicator window.
●
The movement ranges of the function
hand and day indicator are limited when
you rotate the crown. The maximum
left-right movement of the function hand
is 180 degrees in either direction. The
day indicator moves only slightly.
●
After the function hand and day
indicator are in the positions you want,
advance to step 12 of this procedure. If
you are unable to make the adjustments
you want, go to step 10.
10. Press (B).
Confirm that the day indicator shows “1”.
1
1
Day indicator
●
The function hand will move repeatedly
while the day setting is being changed.
The function hand may continue to
move for about 20 minutes.
l
Hand and Day Indicator Movement
11. If “1” is not shown for the day, rotate the
crown until “1” is shown for the day.
●
Rotating the crown also causes the
function hand to move. Move the
function hand to 12 o’clock.
12. Push the crown back in.
Note
●
Leaving the crown pulled out for more
than approximately 30 minutes without
performing any operation will
automatically cause the adjustment
operation to become disabled. If this
happens, push the crown back in to its
normal position and then pull it out
again to restart the procedure from the
beginning. Pushing the crown in to its
normal position part way through the
alignment procedure will cause the
hands to return to their normal position.
Any alignment you performed up to
that point will be applied.
Other Settings
This section explains other watch settings you
can configure.
Resetting Watch Settings
This section explains how to return the watch
settings below to their initial factory defaults.
●
Watch Settings
●
Stopwatch
●
Alarm
1. Enter the Calendar Mode.
l
Navigating Between Modes
2. Pull out the crown to the second click.
This causes the second hand to move to
12 o’clock.
3. Hold down (A) for at least 10 seconds until
the second hand performs one full
rotation.
30
Crown
Second hand
4. Push the crown back in.
Note
●
Resetting the watch will also delete
information for pairing the watch with a
phone, and unpair them.
Watch Operation Guide 5697
20
Loading ...
Loading ...
Loading ...