Loading ...
Loading ...
Loading ...
Care & Cleaning
Raising and lowering the cooktop (some models)
To avoid possible burns DO NOT turn
the surface elements on when the cooktop is raised. Be
sure that the top is completely lowered and securely in
place before turning on any of the surface burners.
When lowering the lift-up range cooktop,
grasp the sides with fingertips only. Be careful not to
pinch fingers. Do not drop or bend the cooktop when
raising or lowering. This may permanently damage the
cooktop surface.
cooktop
\
Relacing oven light (some models)
Be sure the range is unplugged and all parts
are COOL before replacing oven light. Wear a leather-
faced glove for protection against possible broken glass.
To replace oven light: Oven
1. Turn electrical power off at light
the main source or unplug
the range.
2. Replace bulb with a new
40 watt appliance bulb.
3. Turn power back on again
at the main source (or plug
the range back in).
4. The clock will then need to
be reset. To reset see
"Setting clock".
_l_!!i!iiiii:• !ii!_i!!_!_:_!ilyi_
Fig. 1
To raise and lower the cooktop:
1. Remove all items from cookfop and set aside.
2. Grasp the sides of the cooktop and then lift from the
front (See Fig. 1).
3. Lift the cookop high enough to allow the support rods
to snap into place. The lift-up rods will support the
cooktop in the raised position.
4. If necessary, clean underneath using hot, soapy water
and a clean cloth; then dry.
5. To lower the cooktop, grasp the front corner of each
side of the top while pushing back on each rod with
the heel of your hand. This wiJJ release the notched
support. Hold the range cooktop and gently slide the
top back down level to the range.
Aluminum foil and utensils
NEVER cover any slots, holes or passages in
the oven bottom or cover an entire oven rack with materials
such as aluminum foil. Aluminum toll linings may trap heat,
causing a fire hazard.
Protective liners m DO NOT USE
ALUMINUM FOIL to llne the oven bottom, m DO NOT
USE aluminum toll to line surface drip bowls, or reflector
pans. Only use aluminum foil as recommended in this
manual. Improper installation of these liners may result in
risk of electric shock, or fire.
18
Loading ...
Loading ...
Loading ...