Loading ...
Loading ...
Loading ...
Troubleshooting
Pump Alarm- Trouble Code E4
lf a pump alarm is shown on the display, complete the following steps:
2. Manually check to see if the pump is operational by pressing the drain button. Check if
the pump ener-gizes and de-energizes properly.Additionally, check
to see if any water purged from the system.
3. Replace the hoses and/or pump, if maintenance alone isn't sufficient.
1. Reset the unit by disconnecting the power cord and then reconnecting it.
NOTE: UNIT WILL NOT FUNCTION UNTILTHE ERROR CODE HAS BEEN CLEARED.
Symptom
Machine Won't Run
Low Air Flow
Loud Noise
Trouble Code E:1
Trouble Code E: 4
Trouble Code: Hl or LO
Cause
Power Supply
Verify that there is power to the
outlet and that the plug is properly
installed in an outlet.
The unit is outside the operating temperature
range. Modify the room conditions so the
temperature is between 33°F-105°F and
operationwill commence.
Check to ensure that wire is connected at
both ends. If no issues are visible, the sensor
may be faulty.
Move the dehumidifier to flat, firm ground.
Clear the blockage from inlet or outlet.
The unit is outside the operating temperature
range. Modify the room conditions so the
temperature is between 33°F -105°F and
operation will commence. If room is not outof
temperature range, replace faulty the sensor.
Verify that the pump is working. If so, unplug
the unit for two minutes, then restart.
Solution
Room Temperature Over 105°F
(Display HI) or Below 33°F
(Display LO)
Air Inlet or Outlet is Blocked
Machine ls Not Level
E1=Humidity Sensor lssues
Pump has failed
Room Temperature Over 105°F
or Below 33°F(Display Lo)
9
Loading ...
Loading ...