Loading ...
Loading ...
3
2. Wind the search-coil cable around the stem. Use the nylon on the stem to fasten the
cable.(see Figure 2)
3. Rotate the stem’s lock nut clockwise to loosen it. Stand and stretch your arm,
holding your metal detector to make the search-coil hovers above the ground for
about 1 inch. Rotate the stem’s lock nut counterclockwise to tighten it.
4. Loosen the knob at the search-coil’s end, and adjust the search-coil angle to the
desired angle so that it is parallel with the ground. Then tighten the knob.
INSTALLING THE BATTERY
Your metal detector operates with a 9-volt battery(not supplied).The battery
–compartment is located in the headphones. Please make sure the power switch is in
the “OFF” position before installing the battery. Place a coin into the slot on the
ear-cup and turn until the cup “pops” open exposing the battery compartment.( see
Figure 3)
Loading ...
Loading ...
Loading ...