Loading ...
Loading ...
Loading ...
8
7.0 Set-Up and Assembly
7.1 Unpacking and cleanup
Inspect contents of shipping container for shipping
damage. Report any damage to your distributor.
Remove all contents from carton, and compare to
the contents list in this manual. Report any part
shortages to your distributor. Do not discard carton
or packing material until machine is assembled and
running satisfactorily.
Exposed metal areas have a rust preventative
applied. Remove this with a soft rag and solvent or
degreaser. Do not use cellulose-based solvents
such as paint thinner or lacquer thinner; these will
damage painted and plastic surfaces.
7.2 Shipping contents
If you do not see a part below, check the machine;
some parts may have come pre-assembled to the
saw.
Refer to Figures 2 and 3.
1 Band Saw
1 Workstop bar – A
1 Workstop – B
1 Workstop rod – C
1 Filter screen – D
1 Splash guard – E
1 Vertical cutting plate – F
1 Handle – G
1 Axle – H
2 Wheels – I
2 Stand sides – J
2 Stand ends – K
1 Support post – L
1 Instructions and Parts Manual (not shown)
1 Warranty Card (not shown)
Hardware Package (p/n HVBS710S-HP):
4 Hex cap screws 5/16"x3/4" – HP-1
2 Hex cap screws 1/4"x1/2" – HP-2
4 Lock washers 1/4" – HP-3
2 Flat washers 1/4" – HP-4
4 Hex cap screws 5/16"x1-1/2" – HP-5
8 Lock washers 5/16" – HP-6
12 Flat washers 5/16" – HP-7
4 Hex nuts 5/16" – HP-8
2 Cotter pins – HP-9
2 Flat washers 1/2" – HP-10
2 Hex cap screws 1/4"x5/8” – HP-11
Tools required for assembly:
12mm wrench
3, 4, and 6mm hex keys
Figure 2
Figure 3
Hardware package HVBS710S-HP
Loading ...
Loading ...
Loading ...