Loading ...
Loading ...
Loading ...
5
Installation
Notes:
• Supports the connection of two monitors at the same time from a Thunderbolt 3 host
through DisplayPort Multi-Stream Transport (MST) Mode: one monitor via Thunderbolt 3
port and a second monitor via DisplayPort connector.
• Drivers are automatically downloaded and installed during the initial dock connection with
the host computer. The host must have administrative access for the drivers to install
automatically. If this is not possible, the drivers can be downloaded manually via the
product’s webpage at tripplite.com.
• When the included 120W (20V 6A) power supply is connected to the DC power jack, it
supplies power to charge the host PC rst, with the rest of the power supplied to the dock.
• See Optional Accessories section for suggested cables.
• When the unit is connected to the USB-C port on the host computer and to a network using
UTP patch cabling, such as Tripp Lite’s N201-Series Cat6 cables, a network connection will
be established automatically. If no connection is made, one can be established manually by
going to the host computer’s network settings page. For example, on a Mac, navigate to the
Network section in System Preferences, click the “Assist Me” button to get to the Network
Setup Assistant, then follow the prompts to establish a connection.
• MTB3-DOCK-03INT is identical to MTB3-DOCK-03 but with an international power supply.
All installation steps are identical.
1. Connect the included power supply between the unit and a power source.
2. Connect a Thunderbolt 3-enabled laptop or computer to the unit’s Thunderbolt 3
host port using the included Thunderbolt 3 cable.
3. Connect the dock’s DisplayPort connector to a DisplayPort monitor using a
DisplayPort cable, such as Tripp Lite’s P580-Series of DisplayPort cables.
OR
4. Connect the dock’s Thunderbolt 3 output port to a Thunderbolt 3-enabled
monitor using a Thunderbolt 3 cable, such as Tripp Lite’s MTB3-series of
Thunderbolt 3 cables.*
*Note: The DisplayPort and Thunderbolt 3 ports can be used to transmit video
simultaneously in DisplayPort MST Mode. See Multi-Monitor Requirements section for
details.
5. Connect a user-supplied 3.5 mm Mini Stereo cable to the unit to connect an
external speaker.
6. Connect up to three USB devices via the two USB-A ports and USB-C port.
7. Connect the dock’s RJ45 port to a network using a UTP patch cable, such as
Tripp Lite’s N201-Series Cat6 cables.
8. Insert SD or Micro-SD memory cards in the dock’s SD and Micro-SD slots. Both
slots can be used simultaneously.
Loading ...
Loading ...
Loading ...