Lexmark MX810DTE User's Guide PDF Lexmark MX810 Series

Loading ...

The printer has detected a non‑Lexmark supply or part installed in the printer.

Your Lexmark printer is designed to function best with genuine Lexmark supplies and parts. Use of third-

party supplies or parts may aect the performance, reliability, or life of the printer and its imaging

components. For more information, see

“Using genuine Lexmark parts and supplies” on page 251.

All life indicators are designed to function with Lexmark supplies and parts and may deliver unpredictable

results if third-party supplies or parts are used. Imaging component usage beyond the intended life may

damage your Lexmark printer or associated components.

Warning—Potential Damage: Use of third-party supplies or parts can aect warranty coverage.

Damage caused by the use of third-party supplies or parts may not be covered by the warranty.

To accept any and all of these risks and to proceed with the use of non-genuine supplies or parts in your

printer, press and hold

and the # button on the control panel simultaneously for 15 seconds.

If you do not want to accept these risks, then remove the third-party supply or part from your printer and

install a genuine Lexmark supply or part.

Note: For a list of supported supplies, see the “Ordering supplies” section or go to

www.lexmark.com.

Not enough free space in

ﬂash

memory for resources [52]

Try one or more of the following:

• From the printer control panel, touch Continue to clear the message and continue printing.

• Delete fonts, macros, and other data stored in the ﬂash memory.

• Install a ﬂash memory card with larger capacity.

Note: Downloaded fonts and macros not previously stored in the

ﬂash

memory are deleted.

Paper changes needed

Try one or more of the following:

• Touc h Use current supplies to clear the message and continue printing.

• Cancel the current print job.

Parallel port [x] disabled [56]

Try one or more of the following:

• From the printer control panel, touch Continue to clear the message.

• Enable the parallel port. From the printer control panel, navigate to:

Network/Ports > Parallel [x] > Parallel Buer > Auto

Note: The printer discards any data received through the parallel port.

Printer had to restart. Last job may be incomplete.

From the printer control panel, touch Continue to clear the message and continue printing.

For more information, visit

http://support.lexmark.com or contact customer support.

Troubleshooting 302

Loading ...

Lexmark MX810DTE