Loading ...
Loading ...
Loading ...
19
Gas Conversion and Specifications
Convection Oven
1. Carry out the following:-
Remove lower lintel at front of oven.
Open oven door and remove sole plate(s).
Loosen clamp bracket and remove main
burner.
Remove thermocouple and piezo igniter
from mounting bracket. (For access
purposes).
Disconnect pilot supply tube from pilot
burner to access pilot injector.
2. With Main Burner removed, ensure aeration gap is adjusted
for type of gas being used as shown in ‘Gas Specifications
Tables’ at rear of this section.
3. Remove pilot and main injectors and replace with correct
size injectors as shown in ‘Gas Specifications Tables’ at rear
of this section.
4. Refit the following:-
Re-connect pilot supply tube to pilot burner.
Re-connect piezo igniter and thermocouple to mounting bracket.
Refit main burner and secure clamp bracket.
Refit sole plate(s) and lower lintel.
NOTE: There is no 'Low Fire' adjustment on the gas control valve for the GC Oven.
Refit oven control panel.
Gas Regulator
- NAT Gas / LPG / Butane Only.
NOTE: Gas regulator supplied is
convertible between Natural Gas
and LP Gas, but it’s outlet
pressure is fixed ex-factory and is
NOT to be adjusted.
- Town Gas Only.
1. Remove slotted cap from regulator.
2. Turn ‘On’ gas supply and appliance.
3. Adjust pressure adjusting screw to achieve correct burner
operating pressure.
NOTE: Measure operating pressure at manifold test point
with two burners operating at 'High Flame' setting.
4. Verify operating pressure remains correct (Re-adjust regulator
if required).
5. Screw cap nut back onto regulator.
Main Burner Injector
Pilot Burner
Piezo Igniter
Thermocouple
Main Burner
Aeration Slide
Burner Adjustment Screw
NOTE, Pin rotated
for Natural Gas
NOTE, Pin rotated
for LPG
Pressure Adjusting
Screw
Cap Nut
Loading ...
Loading ...
Loading ...