Loading ...
A55483 (Rev. B - 9/10)
Page 2
WALL MOUNT ASSEMBLY
Figure 1
Figure 2
General Instructions
Turn off the water supply at the main source.
Hand tighten all parts prior to tightening with
wrench. Do not force parts together.
Handle plated surfaces with care, being careful
not to scratch with tools.
Wall mount faucets have a ½” I.P.S. female
flanged inlet.
For easier assembly, you may purchase as an
accessory, the LKMK462 mounting kit (see
Figure 2).
Assemble Faucet to Backsplash
1. Apply teflon tape or pipe joint compound to
supply line nipples.
2. Place nipples through holes in backsplash.
3. Assemble each flanged inlet to one nipple, then
the other.
4. Using the optional LKMK462, apply in order
behind the back-splash: rubber washer, washer,
lock nut and elbow (see Figure 2).
5. Thread flanged inlet loosely against wall or
backsplash.
6. Carefully orient, mount and hand tighten the
faucet to the two flanges. Besure to include the
washers provided.
7. Use wrench to tighten flange against
backsplash. (Maintain alignment of faucet or
spout to sink while tightening).
8. Wrench tighten flanges to faucet body.
9. Make sure drain is attached and turn on water
supply - being sure to check for leaks. Wrench
tighten where needed.
Faucet Body
Wall/Backsplash
Escutcheon
2” Offset
1/2” IPS
Supply Line
Nipple
Faucet Body
1/2” IPS by 1/2”
Copper Sweat Elbow
Rubber
Washer
Lock
Washer
Nipple
1/2” Offset
Flanged Inlet
Lock Nut
Sink/Backsplash
Loading ...
Loading ...