Loading ...
Loading ...
Loading ...
11
English
3. Use a 3 mm hex wrench (E) to turn one of the
tracking screws (O) 1/4 turn clockwise. Turn
the other tracking screw 1/4 turn clockwise.
NOTE: Turning the tracking screw clockwise
moves the blade toward the guide roller,
turning the tracking screw counterclockwise
moves the blade away from the guide roller.
4. Tighten both the adjusting locking nuts and
close the quick release lever. (It will be necessary
to run the saw to observe the tracking.)
5. Observe blade tracking between runs and
repeat Steps 1–4 as necessary to achieve
proper blade tracking.
ASSEMBLY AND
ADJUSTMENTS
WARNING: To reduce the risk of serious
personal injury, turn tool off and remove the
battery pack before making any adjustments
or removing/installing attachments or
accessories. An accidental start-up can cause
injury.
P
A
F
K
FIG. 3
M
N
N
D
L L
J
J
Q
G
Installing and Removing the Battery Pack (Fig. 1, 2, 4)
NOTE: For best results, make sure your battery pack is fully charged.
To install the battery pack (P) into the tool handle, align the battery pack with the rails inside the
tool’s handle and slide it into the handle until the battery pack is fi rmly seated in the tool and ensure
that it does not disengage.
To remove the battery pack from the tool, press the release button (Q) and fi rmly pull the battery
pack out of the tool handle. Insert it into the charger as described in the charger section of this
manual.
Q
FIG. 4
Loading ...
Loading ...
Loading ...