Loading ...
Loading ...
Loading ...
Connecting The Water Supply
About your refrigerator's water supply
The automatic ice & water dispenser on your
refrigerator requires a permanent water supply
to function correctly. During installation, you
(or a service professional) establish this water
supply by connecting a copper tube from your
household water system to a valve at the rear of
the refrigerator.
You may have already followed the directions in
the Installation Instructions to connect the water
supply. This information is repeated here for future
reference if you need to relocate your refrigerator.
What you will need:
*Access to a cold water line with pressure of
30-1 O0 psi. (Systemsuppliedwithcold water only.)
*Copper tubing with 1Ainch (6.4mm) Outside
Diameter (OD). Length for this tubing is the
distance from the rear of the refrigerator to
your household water supply line plus seven
feet (2.1 meters).
*A shut-off valve for the connection between
your household water line and the refrigerator
supply line.
Do not use a self-piercing shut-off valve.
.A compression nut and ferrule (sleeve) for
the water supply connection at the rear of
your refrigerator.
3
4
5
6
7
8
9
Unscrew the plastic cap from the water valve
inlet at the rear of your refrigerator. Discard
the cap.
Slide the brass compression nut, then the
ferrule (sleeve) onto copper tube.
Push the copper tube into water valve inlet as
far as it will go (1Ainch).
Slide the ferrule (sleeve) into valve and
finger-tighten the compression nut onto valve.
Tighten another half turn with a wrench. Do
not over-tighten.
Secure the copper tube to your refrigerator's
rear panel with a steel clamp and screw (see
illustration).
Coil the excess copper tubing (about 2Y2
turns) behind your refrigerator as shown.
Arrange coiled tubing to avoid vibration or
wear against other surfaces.
Open water supply shut-off valve and tighten
any connections that leak.
_I_I _ _ Steel
Plastic Water Tubing _/_, Clamp
¢,,Compress,o°
j b_.=_ _ Ferru e
_!'] (sleeve)
_! ate lie
//j_ _ \ Water Valve
_ [_ N..._Bracket
_ _==-Valve Inlet
ater Valve
water line
hold water supply
f?include enough tubing in loop to allow
moving refrigerator out for cleaning.)
To connect the water supply to the rear
of your refrigerator:
1 Ensure that the refrigerator is not plugged in.
2 Flush the supply line until water is clear by
placing the end of the copper tube in a sink
or bucket and opening the shut-off valve.
Loading ...
Loading ...
Loading ...