Euhomy RF-H1 Mini Fridge with Freezer, 3.2 Cu.Ft Compact Refrigerator with freezer, 2 Door Mini Fridge with freezer, Upright for Dorm, Bedroom, Office, Apartment- Food Storage or Drink Beer

Instruction Manual - Page 12

For RF-H1. Also, The document are for others Euhomy models: RF-H

PDF File Manual, 20 pages, Read Online | Download pdf file

RF-H1 photo
Loading ...
Loading ...
Loading ...
Installtion Instructions
8
REVERSE DOOR (OPTIONAL) (CONT .)
11.Remove the 2 screws from the left side and relocate to the right side,.replace the plastic locker
on the fresh door and freezer door bottom in the spare bag.
12.Remove the two plug buttons on the left side at the center and install them on the right.
13.Turn and relocate the center hinge to the left side and reinsert screws. Do not tighten screws yet.
14.Align the fresh food door on the left center hinge. With the magnetic gasket holding the door in
place, make sure the door is aligned with the refrigerator, and secure the bottom hinge on the left
with 3 screws.
15.Ensure fresh food door is properly sealed and leveled before tightening the center hinge screws
and the bottom hinge screws.
16.Raise the refrigerator to the upright position.
17.Place the freezer door on the center hinge over the pin. Ensure the door
is aligned horizontally and vertically, and that the gasket seals on all sides.
18.Turn and relocate the top hinge on the left side with screws.
19.Replace the hinge cover on top of the hinge by sliding it from front to back.
20.Put the 2 plug buttons on the right side on top of the cabinet.
21.Open and close both the freezer and fresh food doors several times to confirm each door is
positioned correctly and the gasket is sealed well. If this is not the case, please adjust the door
again.
22.Wait at least 30 minutes before plugging in the refrigerator to allow the refrigerant to settle down.
Then plug in the unit.
Door Alignment
Freezer Door: (see fig. #1)
1.Remove the top hinge cover.
2.Loosen the top hinge screws using a phillips head screwdriver.
3.Adjust the door or put a spacer in between and then tighten the screws.
4.Replace the top hinge cover.
1
0
2
3
4
5
6
7
fig. # 1
Loading ...
Loading ...
Loading ...