Loading ...
Loading ...
Loading ...
iCE AND WATER DISPENSER FEATURES
The ice and water dispenser convenientUydispenses chHUedwater, and ice cubes or crushed ice, depending on the model
To operate the ice dispenser, seUectthe ice option desired using the touchpad. Press a glass against the dispensing paddUe
as far up as possibUe to catch aHice. To stop dispensing ice, pull gUassaway from dispensing paddUe.Do not remove the
gUassuntil the ice has compUeteUydispensed. (CompUete instructions for the dispenser operation are attached to the inside
of the freezer door.)
How the Water Dispenser Works
The water tank, Uocatedbehind the drawers in the refrigerator compartment, automatically fills as water is dispensed. For
proper dispenser operation, the recommended supply water pressure should fall between 30 psi and 100 psi.
After the refrigerator is connected to the water supply, fill the water tank by drawing one glass of water. It may take about
11/2minutes after activating the dispenser paddle before water begins to fill this first glass. Continue flushing the system
for 3 minutes to rid the tank and plumbing connections of any impurities. The water dispenser has a built in shutoff device
that will stop the water flow after 3 minutes of continuous use. Simply release the dispenser paddle to reset the shutoff
mechanism.
chemicaJs from a malfunctioning softener can damage the ice makerl ff the ice maker is Connected
to soft water, ensure that the softener is maintained and working properly.
How the ice Dispenser Works
The ice maker and container are located in the top of the freezer compartment, After the
refrigerator is installed properly and has cooled for several hours, the ice maker can begin
making ice within 24 hours, Air in new plumbing lines may cause the ice maker to cycle two
or three times before making a full tray of ice, To begin ice production, lower the wire signal
arm to the "down" or ON position, With no usage it will take approximately 2 days to fill the
ice container, The ice maker turns off automatically when the ice container becomes full, To
s,_,_,A_,,, stop the ice maker, lift the wire signal arm until it clicks, and locks in the "up" or OFF
position.
The ice maker produces 4 to 6 pounds of ice every 24 hours depending on usage conditions.
Ice is produced at a rate of 8 cubes every 75 to 90 minutes.
Because of new plumbing connections, the first production of ice cubes may be discolored
or have an odd flavor. These should be discarded until the cubes made are free of discoloration and taste.
iCE DISPENSER TIPS
Ice cubes stored too long may develop an odd flavor, Empty the ice container and ensure that the wire signal arm is
in its "down" or ON position, The ice maker will then produce more ice,
Occasionally shake the ice container to keep ice separated,
Keep the wire signal arm in its "up" or OFF position until the refrigerator is connected to the water supply or whenever the
water supply is turned off,
IMPORTANT: Your ice maker is shipped with the wire signal arm in the ON position, To ensure proper function of
and locks in the UP position. If the icemaker is not turned off and the water supply is not connected, the water valve
!f the d!sPens!ng paddle !s pushed for m0re tha n 4 m!nuteS, the dispense[ motor may 0verload
and stop.The overload protector wiJl reset automatically after 3 or 4minutes.
16
Loading ...
Loading ...
Loading ...