Loading ...
Loading ...
Loading ...
5
2b. Mount on Solid Brick and Concrete Block
WARNING
• When installing wall mounts onto a concrete masonry unit (also known as a CMU or
“cinder block”), verify that the actual concrete thickness is at least 35mm (1-3/8”)
in order to hold the concrete anchors. DO NOT DRILL INTO MORTAR JOINTS! Be
sure to mount the wall mount with the included concrete anchors, D6 washers and
anchor bolts onto solid sections of the blocks. The solid sections can generally be
found 25mm (1”) toward the middle of the block from either end. An electric drill on
a slow setting is suggested to drill the hole rather than a hammer drill so as to avoid
breaking out the back of the hole when entering a hollow section.
• Installers must verify that the supporting surface will safely support the combined
load of the equipment and all attached hardware and components.
Screw the wall
mount onto
the wall
Drill pilot holes
2
Position the Mounting Template
to desired location with the
↑
UP
pointing towards the ceiling
Mark the exact location of the
mounting holes
1
Anchor Bolt
Concrete Anchor
D6 Washer
14-03-249-93332F.indb 5 4/14/2014 10:48:30 AM
Loading ...
Loading ...
Loading ...