Loading ...
Loading ...
Loading ...
English
3
without battery cap. Transporting batteries can possibly
cause fires if the battery terminals inadvertently come in
contact with conductive materials such as keys, coins,
hand tools and the like. The US Department of
Transportation Hazardous Material Regulations (HMR) actu-
ally prohibit transporting batteries in commerce or on air-
planes (i.e., packed in suitcases and carry-on luggage)
UNLESS they are properly protected from short circuits.
So when transporting individual batteries, make sure that the
battery terminals are protected and well insulated from
materials that could contact them and cause a short circuit.
CAUTION: Battery pack must be securely attached to
tool. If battery pack is detached, personal injury may result.
The RBRC™ Seal
The RBRC™ (Rechargeable Battery Recycling
Corporation) Seal on the nickel cadmium and
nickel metal hydride batteries (or battery packs)
indicate that the costs to recycle these batteries
(or battery packs) at the end of their useful life
have already been paid by D
EWALT. In some areas, it is
illegal to place spent nickel cadmium and nickel metal
hydride batteries in the trash or municipal solid waste stream
and the RBRC program provides an environmentally
conscious alternative.
RBRC™ in cooperation with D
EWALT and other battery
users, has established programs in the United States and
Canada to facilitate the collection of spent nickel cadmium
and nickel metal hydride batteries. Help protect our environ-
ment and conserve natural resources by returning
the spent nickel cadmium and nickel metal hydride batteries
to an authorized D
EWALT service center or to your local
retailer for recycling. You may also contact your local recy-
cling center for information on where to drop off the spent
battery.
RBRC™ is a registered trademark of the
Rechargeable Battery
Recycling Corporation.
Important Safety Instructions for
Battery Chargers
SAVE THESE INSTRUCTIONS: This manual contains
important safety instructions for battery chargers.
• Before using charger, read all instructions and cautionary
markings on charger, battery pack, and product using bat-
tery pack.
DANGER: Electrocution hazard. 120 volts are present at
charging terminals. Do not probe with conductive objects.
Electric shock or electrocution may result.
WARNING: Shock hazard. Do not allow any liquid to get
inside charger. Electric shock may result.
CAUTION: Burn hazard. To reduce the risk of injury,
charge only D
E
WALT nickel cadmium rechargeable batteries.
Other types of batteries may burst causing personal injury
and damage.
CAUTION: Under certain conditions, with the charger
plugged in to the power supply, the exposed charging con-
tacts inside the charger can be shorted by foreign material.
Foreign materials of a conductive nature such as, but not lim-
ited to, steel wool, aluminum foil, or any buildup of metallic
particles should be kept away from charger cavities. Always
unplug the charger from the power supply when there is no
battery pack in the cavity. Unplug charger before attempting
to clean.
•
DO NOT attempt to charge the battery pack with any
chargers other than the ones in this manual. The
charger and battery pack are specifically designed to
work together.
• These chargers are not intended for any uses other
than charging D
E
WALT rechargeable batteries. Any
other uses may result in risk of fire, electric shock or
electrocution.
• Do not expose charger to rain or snow.
• Pull by plug rather than cord when disconnecting
charger. This will reduce risk of damage to electric plug
and cord.
• Make sure that cord is located so that it will not be
stepped on, tripped over, or otherwise subjected to
damage or stress.
• Do not use an extension cord unless it is absolutely
necessary. Use of improper extension cord could result
in risk of fire, electric shock, or electrocution.
• An extension cord must have adequate wire size
(AWG or American Wire Gauge) for safety. The small-
er the gauge number of the wire, the greater the capacity
of the cable, that is 16 gauge has more capacity than 18
gauge. When using more than one extension to make up
the total length, be sure each individual extension con-
tains at least the minimum wire size.
Recommended Minimum Wire Size
for Extension Cords
Total Length of Cord
25 ft. 50 ft. 75 ft. 100 ft. 125 ft. 150 ft. 175 ft.
7.6 m 15.2 m 22.9 m 30.5 m 38.1 m 45.7 m 53.3 m
Wire Size AWG
18 18 16 16 14 14 12
• Do not place any object on top of charger or place the
charger on a soft surface that might block the venti-
lation slots and result in excessive internal heat.
Place the charger in a position away from any heat
source. The charger is ventilated through slots in the top
and the bottom of the housing.
• Do not operate charger with damaged cord or plug —
have them replaced immediately.
• Do not operate charger if it has received a sharp
blow, been dropped, or otherwise damaged in any
way. Take it to an authorized service center.
• Do not disassemble charger; take it to an authorized
service center when service or repair is required.
Incorrect reassembly may result in a risk of electric shock,
electrocution or fire.
BEFORE OPERATING THIS TOOL, CAREFULLY READ
AND UNDERSTAND ALL INSTRUCTIONS IN THE
“IMPORTANT SAFETY INSTRUCTIONS” SECTION.
Important Safety Instructions
for Battery Packs
Your tool uses a DEWALT battery pack. When ordering
replacement battery packs, be sure to include catalog num-
ber and voltage: Extended Run-Time battery packs deliver
more run-time than standard battery packs. Consult the chart
at the end of this manual for compatibility of chargers and bat-
tery packs.
NOTE: Your tool will accept either standard or Extended Run
Time battery packs. However, be sure to select proper volt-
age. Batteries slowly lose their charge when they are not on
the charger, the best place to keep your battery is on the
charger at all times.
The battery pack is not fully charged out of the carton. Before
using the battery pack and charger, read the safety instruc-
tions below. Then follow charging procedures outlined.
READ ALL INSTRUCTIONS
• Do not incinerate the battery pack even if it is
severely damaged or is completely worn out. The
battery pack can explode in a fire.
• A small leakage of liquid from the battery pack cells
may occur under extreme usage or temperature con-
ditions. This does not indicate a failure. However, if the
outer seal is broken and this leakage gets on your skin:
a. Wash quickly with soap and water.
b. Neutralize with a mild acid such as lemon juice or
vinegar.
c. If battery liquid gets into your eyes, flush them with
clean water for a minimum of 10 minutes and seek
immediate medical attention. (Medical note: The
liquid is 25-35% solution of potassium hydroxide.)
• Charge the battery packs only in D
E
WALT chargers.
• DO NOT splash or immerse in water or other liquids.
• Do not store or use the tool and battery pack in loca-
tions where the temperature may reach or exceed
105°F (such as outside sheds or metal buildings in
summer).
DANGER: Electrocution hazard. Never attempt to open
the battery pack for any reason. If battery pack case is
cracked or damaged, do not insert into charger. Electric
shock or electrocution may result. Damaged battery packs
should be returned to service center for recycling.
NOTE: Battery storage and carrying caps are
provided for use whenever the battery is out of
the tool or charger. Remove cap before placing
battery in charger or tool.
WARNING: Fire hazard. Do not store or
carry battery so that metal objects can
contact exposed battery terminals. For example, do not
place battery in aprons, pockets, tool boxes, product kit
boxes, drawers, etc., with loose nails, screws, keys, etc.
632246-00,01,DC628 8/29/06 6:26 PM Page 3
Loading ...
Loading ...
Loading ...