Loading ...
Loading ...
Loading ...
14
3 in 1: Grass Trimmer/Edger/Mini mower
EN
ASSEMBLY & OPERATION
Action Figure
ASSEMBLY
Assembling the Safety Guard See Fig. A1, A2
Mounting the Edger /Trimming
Support Wheels
NOTE: There are three optional
positions for the Edger /Trimming
Support Wheels to attach when
assisting in Trimming and Edging.
Fig. B1 is for Edging. Fig. B2 and B3
is for Trimming.
See Fig. B1,
B2, B3
Installing and Removing the Battery
Pack
Your Battery Pack is UNCHARGED
and it must be fully charged once
before it is used.
See Fig. C
Checking the Battery Condition See Fig. D1
Charging the Battery Pack
More details can be found in char-
ger’s manual
WARNING! The charger and
battery pack are specially
designed to work together so do
not attempt to use any other devic-
es. Never insert or allow metallic
objects into your charger or battery
pack connections because of an
electrical failure and hazard will
occur.
See Fig. D2
OPERATION
Safety ON/OFF Switch
WARNING! The cutting
head continues to rotate
after the trimmer has been
switched off; wait until it has
completely stopped then lay down
the tool.
WARNING!Make sure
that line is fed out before
operation. Make sure motor is up
to full speed before trimming or
edging.
See Fig. E
Adjusting the Shaft See Fig. F
Adjusting the Auxiliary handle See Fig. G
Using the Flower Guard See Fig. H
Trimming
- Adjusting the Trimmer Head
NOTE: The trimmer head must be
locked as Fig. I4.
See Fig. I1, I2,
I3, I4
- Trimming / Mowing
NOTE:
• For trimming/mowing Fig. J1,
please mount the wheels following
Fig. B2. For trimming in Fig. J2,
please mount the wheels following
Fig. B3.
• You could also use the machine
without the guide wheels on the
guard when trimming.
See Fig. J1, J2
Edging
- Main handle rotation
“Secure the lower housing and
guard in place (using your foot or
hand).
Pull up on the telescopic shaft and
turn clockwise 90 degrees.
Release, and the shaft will
automatically lock into edging
mode.”
See Fig. K1, K2
- Changing the tool into the Edging
mode
See Fig. K3,
K4, K5
- Edging See Fig. K6
Command feeding the line
NOTE: Press as needed.
See Fig. L
Manually feeding the line
See Fig. M
Replacing the trimmer Spool
See Fig. N1,
N2, N3
Manually winding the line
See Fig. O1, O2,
O3, O4
Spool holder
NOTE: Allows for an additional
spool to be stored on the tool.
See Fig. P
LINE FEEDING/WINDING
INSTRUCTION
1. Automatic line feed system
When initially switching on the trimmer, a small
length of line is fed out. Each time the tool is started
from rest it will advance about 0.25 inches of trimmer
line.
A ‘clattering’ noise will be heard when the lines hit
the Line Cutter. DO NOT BE ALARMED. This is quite
normal. After about 5 seconds the line will be cut to
the correct length and the noise will reduce as the
motor gains full speed.
If the noise of the line being cut can’t be heard, more
line will need to be fed out.
To feed more line, it is first necessary to allow the
trimmer to stop completely; it must come to a
Loading ...
Loading ...
Loading ...