Loading ...
Loading ...
Loading ...
11
operaTion
Temperature Display - Figure 8
In normal operation, the following settings will be
displayed:
• the average refrigerator temperature
• the warmest frozen food temperature.
When starting up for the first time or when
the appliance is warm, dashes will appear
in the freezer temperature display, until the
temperature in the freezer compartment is
32°F (0°C).
It will take between three and eight hours for the required
temperature, 0°F or 38°F (-18°C or 3°C) to be reached
and displayed permanently in the display, depending on
the ambient conditions and the temperature setting.
The display will flash:
• if you change the temperature or
• if the temperature rises by several degrees, indicat-
ing cold loss, e.g. if you place fresh, “warm” food in
the freezer or if you remove or repack frozen food, the
temperature may rise for a short time due to warm air
flowing into the freezer.
• If “F1” to “F5” appears in the display, the appliance
has a fault. Have the fault number available when you
contact the customer service department.
Audible Alarm Signal - Figure 8
The audible alarm signal helps to protect frozen food and
to save energy.
The audible alarm signal is switched o by touching
the alarm icon.
Audible door alarm
This sounds when the door has been left open for longer
than about 180 seconds. The sound switch-off func-
tion is active as long as the door is left open. The alarm
automatically switches back to standby when the door is
shut.
Audible/visual temperature alarm
It always sounds if the freezer temperature is not low
enough. The temperature display and the alarm LED
flashes at the same time.
This can be caused by:
- warm, fresh food being placed in the freezer;
- too much warm air from the outside entering when re-
arranging or removing frozen food,
- a fault in the appliance.
The temperature display will continue to flash until the
cause of the alarm has been rectified. It will then stop
flashing and light up continually. The audible warning
signal is now automatically reset.
Power Failure/Frost-Control Display -
Figure 8
If the power failure LED is lit, this means the freezer
temperature has risen too high during the last few hours
or days due to a power failure. The freezer temperature
display flashes at the same time.
• If you touch the Alarm icon now, the highest tempera-
ture registered during the power failure will be dis-
played.
• Check the quality of the food in case it has become
too warm or even defrosted.
• The highest temperature will appear for approximately
one minute. After that, the actual temperature in the
freezer will reappear.
The display can be turned off by touching the Alarm
icon again.
Supercool - Figure 8
Touching the Supercool icon switches the refrigerator
compartment to maximum cooling. It is recommended
particularly if you wish to cool large quantities of food,
drinks, freshly baked goods or meals rapidly.
• Turning on: Touch the Supercool icon briefly so the
LED turns on. The refrigerator temperature will
drop to its lowest value.
IMPORTANT
The Supercool function uses slightly more energy.
After approximately six hours, however, the refrig-
erator switches back automatically to normal ener-
gy-saving operation. If required, the Supercooling
function can be turned off sooner.
• Turning off: Touch the Supercool icon again until the
LED
turns off.
Loading ...
Loading ...
Loading ...