Loading ...
Loading ...
Loading ...
MAINTENANCE
CLEANING THE FILTER AND
SEPARATOR
1
Open the dirt cup lid to access the filter and
separator.
2
To clean the separator, lift to remove. Clean dirt
and debris by wiping the metal screen with a
cloth and then place back into the dirt cup.
3
Pull the filter away and tap over a trash can to
remove dirt. Rinse filter under warm water until
water comes out clear. Allow filter to air dry for at
least 24 hours until fully dry.
THE BELT: This vacuum is equipped with the
fiber reinforced stretch belt, which is designed
for long life and doesn’t need changing.
THERMAL PROTECTOR:
A THERMAL PROTECTOR HAS BEEN DESIGNED
INTO YOUR CLEANER TO PROTECT IT FROM
OVERHEATING. WHEN THE THERMAL
PROTECTOR ACTIVATES THE CLEANER WILL
STOP RUNNING.
If this happens proceed as follows:
1. Turn cleaner OFF and remove battery pack.
IMPORTANT: If left turned on, the cleaner
motor may restart unexpectedly.
2. Empty dirt cup.
3. Inspect the filter and cyclone for any
obstructions. Clear obstructions if present.
4. After the battery pack is removed and the
motor cools for 30 minutes, reinstall the
battery pack. The thermal protector will
deactivate and cleaning may continue.
If thermal protector continues to activate after
following the above steps, your cleaner needs
servicing, call Customer Service at
1800406-2005.
REMOVING AND REPLACING THE
BRUSH ROLL
WARNING: To reduce the risk of
injury from moving parts - Remove battery
before servicing.
WARNING: Risk of personal injury
- Brush roll may suddenly restart. Turn power
switch o and remove battery before cleaning
or servicing.
1
Using your fingers or a coin, push and turn the
brush roll lock counterclockwise to release the
brush roll.
2
Pull the brush roll out of the nozzle with the
pull tab.
3
To remove any threads or hair, slide the blade of
a pair of scissors into the groove of the brush roll
and cut along the groove. Clear any dirt/debris
from the end caps and inside the housing of the
nozzle.
4
Re-fit the brush roll into the nozzle and turn the
brush roll lock clockwise to lock.
LUBRICATION: The motor and brush roll are
equipped with bearings which contain sucient
lubrication for their lifetime. The addition of
lubricant could cause damage. Do not add
lubricant to motor or brushroll.
ACCESSORIES
Look for these accessories on Hoover.com or Hoover.ca or call 1-800-406-2005.
EVERY ONEPWR™ BATTERY WORKS WITH EVERY ONEPWR™ PRODUCT.
BATTERY: MODEL #
2.0 Ah BH15020, BH19020
3.0 Ah BH15030, BH25030
4.0 Ah BH15240, BH25040, BH19240, BH29040
8.0 Ah BH25280, BH29280
PARTS AND ACCESSORIES:
Single Bay Charger BH05000
Dual Bay Charger BH05200
Fast Charger BH05140
Slide-On 0.5A Compact Charger 440014514, 440014913
Slide-On 1.5A Compact Charger 440014513, 440014914
To register your product, go to the URL below and follow the steps until complete.
Hoover.com/product-registration
TROUBLESHOOTING
WARNING: To reduce the risk of personal injury - Remove the battery before
cleaning or servicing.
THIS PRODUCT CONTAINS NO SERVICEABLE PARTS.
IF APPLIANCE IS NOT WORKING AS IT SHOULD, HAS BEEN DROPPED, DAMAGED, LEFT OUTDOORS, OR
DROPPED INTO WATER, CALL CUSTOMER SERVICE AT 1800406-2005 PRIOR TO CONTINUING USE.
Loading ...
Loading ...
Loading ...