Loading ...
Loading ...
Loading ...
31
Refitting door panels on the appliance
1.
Insert the front panel downwards into the retainers
(figure
!).
2.
Close the front panel until the two upper hooks are
opposite the opening (figure ").
3.
Push the front panel in at the bottom until you hear it
click into place (figure #).
4.
Open the appliance door a little and remove the dish
towel.
5.
Screw both screws back in on the left and right.
6.
Put the cover back in place and press on it until it
clicks audibly into place (figure
$).
7.
Close the appliance door.
9 CAUTION
Do not use the cooking compartment again until the
panels have been correctly fitted.
Troubleshooting
Faults often have simple explanations. Before calling
customer service, please refer to the table below and
attempt to correct the fault yourself.
9 CAUTION
Repairs should only be done by an authorized
servicer.
Improper repair of your appliance may result in risk
of severe physical injury or death.
Eliminating faults yourself
You can often easily eliminate technical faults on the
appliance yourself.
If a dish does not turn out exactly as you wanted, you can
find many tips and instructions for preparation at the end
of the operating manual. ~ "Tested for you in our
cooking studio" on page 37
2
1
Fault Possible cause Notes/remedy
The appliance does not work. Faulty fuse. Check the circuit breaker in the fuse box.
Power failure Check whether the kitchen light or other kitchen appliances
are working.
“Language English”
appears on the display.
Power failure Reset the language and the time.
The time does not appear
when the appliance is
switched off.
Basic setting is
changed.
Change the basic setting for the clock display.
The appliance does not heat
up; the m symbol lights up
on the display.
Demo mode is acti-
vated in the basic set-
tings.
Briefly disconnect the appliance from the mains (switch off
the circuit breaker in the fuse box) and then deactivate demo
mode in the basic settings within 3 minutes.
The appliance will not start
and "Cooking compartment
too hot" appears on the dis-
play
The cooking compart-
ment is too hot for the
selected dish or type of
heating
Allow the cooking compartment to cool down and start again
The rotary selector has fallen
out of the support in the con-
trol panel.
The rotary selector has
been accidentally dis-
engaged.
The rotary selector can be removed. Simply place the rotary
selector back in its support in the control panel and push it in
so that it engages and can be turned as usual.
Loading ...
Loading ...
Loading ...