Loading ...
Loading ...
Loading ...
Your new tractor has been assembled at the factory. Review the video cassette before
you begin.
When right or left hand is mentioned in
this manual, it means, from your point of
view, when you are in the operating posi-
tion (seated behind the steering wheel).
TO REMOVE TRACTOR FROM
CARTON
UNPACK CARTON
1. Cut, from top to bottom, along lines
on all four corners of carton, and lay
panels flat.
2. Remove packing materials.
3. Remove protective materials from trac-
tor hood and grill.
IMPORTANT: Check for and remove any
staples in skid that may puncture tires
where tractor isto rolloff skid.
CHECK BATTERY
1, Lift hood to raised position,
NOTE: If this battery is put into service
after month and year indicated on label
(label located between terminals) charge
battery for minimum of one hour at 6-10
amps. (See "BATTERY" in Maintenance
section of this manual for charging instruc-
tions).
2. Release LH. seat slide on seat pan by
pulling out on adjustment handle and
sliding it to the rear position exposing
seat mounting holes from bottom. Slide
R.H. slide to same rear position.
3. Mount rear of seat on slides using
mounting bolts and lock washers as
shown.
4. Pull out on adjustment handle and
slide seat all the way forward. Install
front mounting bolts and lock washers.
Tighten all mounting bolts securely.
5. Lower seat into operating position and
sit on seat. Press clutch/brake pedal all
the way down. If operating position is
not comfortable, adjust seat.
To adjust seat: Grasp adjustment handle
and pull out, slide seat to desired position
and release adjustment handle.
L.h. Seat
Adjustment Seat
Seat
Lock
Washer
-" ."'" :" Label
INSTALL sEAT
Seat position should be adjusted forward
or backward so that the operator can
comfortably reach clutch/brake pedal and
safely operate the tractor,
1. Remove the two (2) bolts and flat
washers securing the seat to cardboard
packing. Keep the two (2) bolts only
and place them with the two (2) identi-
cal bolts and four (4) washers in the
parts bag. Discard the flat washers and
cardboard packing.
Slide
Mounting Bolts l
NOTE: You may now rollor drive your
tractor off the skid. Follow the appropriate
instructionbelow to remove the tractor
from the skid.
TO ROLLTRACTOR OFF SKID (See
Operation section for location and
function of controls)
1. Press lift lever plunger and raise
attachment lift lever to its highest po-
sition.
2. Release parking brake by depressing
brake pedal.
3. Place freewheel control in transmission
disengaged position (See =To Trans-
port" in the Operation section of this
manual).
4. Roll tractor forward off skid.
7
Loading ...
Loading ...
Loading ...