Loading ...
Loading ...
Loading ...
8
CUSTOMER SUPPORT TEAM: +44 (0) 333 220 6056
USING YOUR APPLIANCE
Control Panel:
• Thermostat control dial – adjust to
maintain room temperature
• Power/ame switch – switches both
ame eect and power
ON/OFF
• 1000W heat selection –
Push switch ‘I’
to the ON position for 1000W.
• 2000W heat selection –
Push switch ‘I’
to the ON position
and
‘II’
at the same
time for 2000W heating. The higher
heating selection cannot be activated
without rst activating the 1000w
setting.
The ame eect can be operated with or
without heat.
Using the Timer:
1. Plug the heater into the mains socket and
switch the socket on.
2. The heater switches are located at the
back of the unit above the exhaust vents.
3. Switch the re on by pushing the ON/OFF
switch to the ‘I’ position.
4. To select the heat level, you can choose
between two settings: 1000W or 2000W.
5. Push switch ‘I’ to the ON position for
1000W.
6. Push switch ‘II’ to the ON position for
2000W.
7. Rotate the thermostat dial clockwise or
counter-clockwise to increase or decrease
the desired room temperature setting.
8. To turn o, push all the switches to the
OFF positions.
Safety Cut-Off:
This appliance is tted with a safety cut-o
which will operate if the heater overheats (e.g.
Due to blocked air vents). For safety reasons,
the heater will NOT automatically reset.
To reset the appliance, disconnect the
appliance from the mains supply for at least 15
minutes. Reconnect the supply to the mains
and switch on the appliance.
UNPLUG THE PRODUCT WHEN IT’S NOT
IN USE.
Troubleshooting:
• The heater will not turn on / The fan
will not turn on.
Make sure the appliance is plugged into
the mains and that it is switched on. If
plugged in, make sure the Power button
is in the On position. Check that the safety
cut-o feature has not been activated.
• No fire effect light.
Check with the manufacturer or a qualied
service person for repair
Loading ...
Loading ...
Loading ...