Bosch KAA92LB35I/01 Serie 8 Side-by-side fridge-freezer

Installation instructions - Page 5

For KAA92LB35I/01. Also, The document are for others Bosch models: KAA..

PDF File Manual, 24 pages, Read Online | Download pdf file

KAA92LB35I/01 photo
Loading ...
Loading ...
Loading ...
en
5
The product is not meant for re-sale to any
unauthorized agencies/scrap dealer/kabariwalah.
The product is not meant for mixing into
household waste stream.
Do not keep any replaced spare part(s) from the
product in exposed area.
3. Any disposal through unauthorized agencies/person
will attract action under Environment (Protection)
Act 1986.
Note
This product doesn´t use any hazardous -substances
as specified in the E-waste (Management) Rules 2016.
Scope of delivery
After unpacking all parts, check for any damage in
transit.
If you have any complaints, please contact the dealer
from whom you purchased the appliance or our
customer service.
The delivery consists of the following parts:
Free-standing appliance
Bag containing installation materials
Interior fittings (depending on model)
Operating instructions
Customer service booklet
Warranty enclosure
Information on the energy consumption and noises
Installing the appliance
Transporting
The appliance is heavy. Secure in position during
transportation and installation.
Due to the weight/dimensions of the appliance and to
minimise the risk of injury and damage to the appliance
at least two persons are necessary to set-up the
appliance safely.
Installation location
Install the appliance in a dry, well ventilated room.
The installation location should neither be exposed
to direct sunlight nor near a heat source, e.g. a cooker,
radiator, etc. If installation next to a heat source is
unavoidable, use a suitable insulating plate or observe
the following minimum distances to a heat source:
3 cm to electric or gas cookers.
30 cm to an oil or coal-fired cooker.
If installing the appliance next to another refrigerator
or freezer, ensure a minimum lateral distance of 25 mm
to prevent the formation of condensation.
If a panel or cupboard is installed above the appliance,
ensure that a gap of 30 mm is left so that the appliance
can be pulled out of the recess if required.
The air heated on the rear side of the appliance must
be allowed to escape unhindered.
Base
m Caution
The appliance is very heavy.
The appliance may weigh up to 140 kg depending on
the model.
The floor at the installation location must not sag; if
necessary, reinforce floor.
To ensure that the doors can open all the way, observe
the side minimum distances when installing the
appliance in a corner or recess (see chapter Installation
dimensions).
If the depth of adjacent kitchen equipment is over
60 cm, observe the minimum side distances to utilise
the full door opening angle (see chapter Door opening
angle).
Loading ...
Loading ...
Loading ...